Compton imaging using high resolution scintillation detectors

Y. Zhang,S. Mungai,Z. Kuang,N. Ren,Y. Yang,Z. Liu
DOI: https://doi.org/10.1109/NSSMICRTSD49126.2023.10338533
2023-01-01
Abstract:A prototype Compton camera is built by using an ultra-high spatial resolution scatter detector consisting of a gadolinium aluminum gallium garnet (GAGG) scintillator array with a crystal size of 0.35×0.35×3 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sup> read out by a SiPM array and a high 3D spatial resolution absorb detector consisting of an lutetium yttrium orthosilicate (LYSO) scintillator array with a crystal size of 1×1×20 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sup> dual-ended read out by SiPM arrays. A novel image reconstruction algorithm that combines a simple back-projection method and a MLEM method was also developed and tested by using Monte Carlo simulation data. The performance of the detectors were measured. The results showed that all but the edge crystals can be clearly resolved and average energy resolutions of 13.5% and 19.1% were achieved for the two detectors. In the next step, point source and phantom data will be acquired using the prototype Compton camera. The spatial resolution, sensitivity and image performance of the prototype Compton camera will be evaluated.
What problem does this paper attempt to address?