Abstract:A depth encoding PET detector module using semi-monolithic scintillation crystal single-ended readout by a SiPM array was built and its performance was measured. The semi-monolithic scintillator detector consists of 11 polished LYSO slices measuring 1 × 11.6 × 10 mm3. The slices are glued together with enhanced specular reflector (ESR) in between and outside of the slices. The bottom surface of the slices is coupled to a 4 × 4 SiPM array with a 1 mm light guide and silicon grease between them. No reflector is used on the top surface and two sides of the slices to reduce the scintillation photon reflection. The signals of the 4 × 4 SiPM array are grouped along rows and columns separately into eight signals. Four SiPM column signals are used to identify the slices according to the center of the gravity of the scintillation photon distribution in the pixelated direction. Four SiPM row signals are used to estimate the y (monolithic direction) and z (depth of interaction) positions according to the center of the gravity and the width of the scintillation photon distribution in the monolithic direction, respectively. The detector was measured with 1 mm sampling interval in both the y and z directions with electronic collimation by using a 0.25 mm diameter 22Na point source and a 1 × 1 × 20 mm3 LYSO crystal detector. An average slice based energy resolution of 14.9% was obtained. All slices of 1 mm thick were clearly resolved and a detector with even thinner slices could be used. The y positions calculated with the center of gravity method are different for interactions happening at the same y, but different z positions due to depth dependent edge effects. The least-square minimization and the maximum likelihood positioning algorithms were developed and both methods improved the spatial resolution at the edges of the detector as compared with the center of gravity method. A mean absolute error (MAE) which is defined as the probability-weighted mean of the absolute value of the positioning error is used to evaluate the spatial resolution. An average MAE spatial resolution of ~1.15 mm was obtained in both y and z directions without rejection of the multiple scattering events. The average MAE spatial resolution was ~0.7 mm in both y and z directions after the multiple scattering events were rejected. The timing resolution of the detector is 575 ps. In the next step, long rectangle detector will be built to reduce edge effects and improve the spatial resolution of the semi-monolithic detector. Thick detector up to 20 mm will be explored and the positioning algorithms will be further optimized.

The Performance of the New KETEK Low-Noise SiPM Array Series: Characterization in a Compton Camera Study

Compton imaging using high resolution scintillation detectors

Study of the \begin{document}${\gamma} $\end{document} -Ray Detector of Dual-ended Readout Based on SiPM

Advances in High-Energy-Resolution CdZnTe Linear Array Pixel Detectors with Fast and Low Noise Readout Electronics

Performance evaluation of a GAGG-SiPM based Compton camera for gamma-ray astronomy

Theory of a stable strong electrostatic double layer generated in a two-grid Franck-Hertz tube

Characterization of a SiPM-based monolithic neutron scatter camera using dark counts

Performance of a SiPM Based Semi-Monolithic Scintillator PET Detector

Silicon photomultiplier-based scintillation detectors for photon-counting CT: A feasibility study

Silicon photomultiplier arrays - a novel photon detector for a high resolution tracker produced at FBK-irst, Italy

An enhanced high-resolution EMCCD-based gamma camera using SiPM side detection

A performance study of an electron-tracking Compton camera with a compact system for environmental gamma-ray observation

A Prototype of SiPM-based Scintillator Compton Camera with Capacitive Multiplexing Readout

Scintillation detectors constructed with an optimized 2x2 silicon photomultiplier array

Preliminary Results of a Compton Camera Based on a Single 3D Position-Sensitive CZT Detector

Novel sensor developments for photon science at the MPG semiconductor laboratory

CdTe Based Energy Resolving, X-ray Photon Counting Detector Performance Assessment: The Effects of Charge Sharing Correction Algorithm Choice

Signal Characteristics Study of Continuous Scintillator CCD-based Single Photon Counting (SPC) Detector

Evaluation and synthesis of perovskite crystals as high-Z sensors for hybrid pixel detectors

DOI- and TOF-capable PET Array Detector Using Double-Ended Light Readout and Stripline-Based Row and Column Electronic Readout