Triple Halide Wide Bandgap Perovskites for Efficient Indoor Photovoltaics

Shaoyang Wang,Paul R. Edwards,Maged Abdelsamie,Peter Brown,David Webster,Arvydas Ruseckas,Gopika Rajan,Ana I. S. Neves,Robert W. Martin,Carolin M. Sutter-Fella,Graham A. Turnbull,Ifor D. W. Samuel,Lethy Krishnan Jagadamma

DOI: https://doi.org/10.48550/arXiv.2301.13772

2023-01-31

Applied Physics

Abstract:Indoor photovoltaics are receiving tremendous attention due to the continuous development of the Internet of Things (IoT). Here we report a triple anion (TA) perovskite CH3NH3PbI2.6(BrCl)0.2 with a tailored bandgap suitable for maximizing indoor light harvesting compared to methyl ammonium lead iodide CH3NH3PbI3. The best-performing TA perovskite indoor-photovoltaic device achieved a steady-state power conversion efficiency (PCE) of 25.1% with an output power density of ~ 75 microW/cm2 under 1000 lux indoor illumination (0.3 mW/cm2 irradiance). This PCE is almost 40% higher than that of equivalent CH3NH3PbI3-based devices (PCE of 17.9%). Longer carrier lifetime, reduced density of trap states and improved crystalline quality were achieved by the triple anion alloying method. The decisive role of chlorine (Cl) in the better performance of TA-based indoor photovoltaic devices was further investigated by successively reducing the Cl content and correlating it with the corresponding photovoltaic device performance. Replacing the commonly used hole transporting layer of Spiro-MeOTAD with undoped P3HT was found to significantly reduce the current-voltage hysteresis under indoor lighting conditions. A graphene-coated textile fiber-based temperature sensor was successfully powered by the triple anion perovskite indoor photovoltaic devices. The results from the present study demonstrate a novel route to maximize the PCE of halide perovskite indoor photovoltaic devices and their potential for application in the IoT industry.