Abstract:Ash aerosol and ash deposit formation during oxy-coal combustion were explored through experiments in a self-sustained 100kW rated down-fired oxy-fuel combustor. Inlet oxidant conditions consisted of 50% inlet oxygen with CO2 (hereafter denoted as OXY50 conditions). A Berner low pressure impactor (BLPI), a scanning mobility particle sizer (SMPS), and an aerodynamic particle sizer (APS) were used to obtain size segregated ash aerosol samples and to determine the particle size distributions (PSD). A novel surface temperature controlled ash deposition probe system that allowed inside and outside deposits to be separated was used to collect the ash deposits. The ash aerosol PSDs given by the BLPI and those produced by SMPS/APS were consistent with each other. Data suggested that oxy-coal combustion under these conditions did not change the formation mechanisms controlling the bulk ash aerosol composition, but it did increase the formation of ultra-fine particles initially formed through metal vaporization, due to increased vaporization of silicon at the higher combustion temperature. The smaller particles contained within the deposits had higher Si and lower Na and S concentrations under OXY50 conditions than for air combustion. Moreover, the ash aerosol composition for particle sizes less than 2.4μm was related to the composition of the inside deposits. A higher Na in the ash aerosol resulted in higher Na in inside deposits with comparable absolute Na concentrations in both those aerosol particles and those inside deposits particles. The contribution of S and Si to the inside deposits showed that S in the vaporization modes together with Si in the ultrafine vaporization mode, contributed significantly to the composition of the inside deposits. These results provided direct evidence that prediction of the chemistry of the initial deposit layer (but not of the bulk deposits) required knowledge of the size segregated chemistry of the ash aerosol.

Regenerative Soot-V: Spectroscopy of the regenerative sooting discharges

Regenerative Soot-IV: The state of the carbon vapour in the regenerative sooting discharge

Regenerative Soot-II: Emission of carbon clusters from sooting plasma

Regenerative Soot-III: Role of the kinetic and potential sputtering in the regeneration of the soot

Regenerative Soot: A cusp field, graphite hollow cathode, carbon cluster ion source

Regenerative Soot-VIII: Sputtering and formation of C1 and C2

Transition from the C3-dominated discharge to the sooting plasma

Large Eddy Simulation of Soot Formation in a Turbulent Lifted Flame with a Discretized Population Balance and a Reduced Kinetic Mechanism

Ash Aerosol Formation from Oxy-Coal Combustion and Its Relation to Ash Deposit Chemistry

Growth of Polycyclic Aromatic Hydrocarbon and Soot Inception by in silico Simulation

Quantifying Evolution of Soot Mixing State from Transboundary Transport of Biomass Burning Emissions

Experimental Analysis of the Evolution of Soot Structure During CO2 Gasification

Elucidating the polycyclic aromatic hydrocarbons involved in soot inception

Advanced characterization of soot precursors via excitation emission matrices fluorescence spectroscopy and molecular modeling

Discrete element method model of soot aggregates

Structure and Behavior of Soot in Pulverized-Coal Flame

Experimental Investigation of Soot Morphology and Primary Particle Size along Axial and Radial Direction of an Ethylene Diffusion Flame Via Electron Microscopy

Evolution of physicochemical characteristics of soot in a single coal combustion flame

Evolution of clusters in energetic heavy ion bombarded amorphous graphite-III: Photo-emission and velocity analysis of sputtered carbon clusters

Molecular dynamics simulations of laser-induced incandescence of soot using an extended ReaxFF reactive force field

Experimental Studies on Soot in MILD Oxy-Coal Combustion Flame: Sampling, Microscopic Characteristics, Chemical Compositions and Formation Mechanism