Abstract:Autothermal reforming (ATR) is an important technology for hydrogen production from natural gas, where soot formation deserves particular attention as it may cause catalyst poisoning. The typical configuration of ATR reactors is that of an inverse diffusion flame (IDF). In this study, soot formation near ATR condi-tions is investigated experimentally and numerically, focusing on the effects of pressure and CO2 dilution in IDFs with pressure reaching 5 bar. The fuel stream consists of methane diluted with CO2 or N2. The mole fraction of O2 in the oxidant stream is 70%. Polycyclic aromatic hydrocarbons (PAHs) and soot vol -ume fraction are measured by the planar laser-induced fluorescence (PLIF) and planar laser-induced in-candesce (PLII) methods. High-fidelity simulations with a detailed soot aerosol model are also performed, and an empirical reactive soot inception model is proposed. A comparison of the results shows that the soot behavior is well predicted by the empirical reactive inception model but not fully captured by the physical inception model based on irreversible dimerization, demonstrating the importance of radical in-volvement in the soot inception process. Both measurements and predictions show a linear relationship between peak soot volume fraction and pressure, which can be explained by the linear increase of PAH molar concentration with pressure. Simulation analysis indicates that the dimer adsorption and HACA mechanism have a similar quantitative contribution to the soot growth. The CO2 shows stronger suppres-sion effects in soot formation at the investigated pressures compared to N2. The contributions of chemical and thermal effects to soot suppression are numerically analyzed and the results indicate that the chem-ical effect of CO2 is mainly due to the removal of H radicals through the reaction CO2 + H & RARR; CO + OH, providing a soot suppression contribution of two times larger compared to the thermal one.& COPY; 2023 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Regenerative Soot-VIII: Sputtering and formation of C1 and C2

Regenerative Soot-III: Role of the kinetic and potential sputtering in the regeneration of the soot

Regenerative Soot-V: Spectroscopy of the regenerative sooting discharges

Regenerative Soot-IV: The state of the carbon vapour in the regenerative sooting discharge

Regenerative Soot-II: Emission of carbon clusters from sooting plasma

Effect of Pressure and CO2 Dilution on Soot Formation in Laminar Inverse Coflow Flame at Conditions Close to Autothermal Reforming

Transition from the C3-dominated discharge to the sooting plasma

Regenerative Soot: A cusp field, graphite hollow cathode, carbon cluster ion source

Chemical Suppressive Effect of Ammonia Addition on Soot Formation in Laminar Diffusion Flames

Study On Re-Sputtering During Cnx Film Deposition Through Spectroscopic Diagnostics Of Plasma

Amorphous carbon films in direct current magnetron sputtering from regenerative sooting discharge

Photoemission Study of Amorphous Carbon Modifications and Comparison with Calculated Densities of States

Evolution of clusters in energetic heavy ion bombarded amorphous graphite-III: Photo-emission and velocity analysis of sputtered carbon clusters

Growth of Polycyclic Aromatic Hydrocarbon and Soot Inception by in silico Simulation

Optimization of Carbon Nanotube Production by Arc-Discharge

Advanced characterization of soot precursors via excitation emission matrices fluorescence spectroscopy and molecular modeling

Elucidating the polycyclic aromatic hydrocarbons involved in soot inception

Ar–CO2 Mixture Plasma Jet Driven by Nanosecond Pulse at Atmospheric Pressure: Discharge Characteristics and Composition Analysis

Plasma treatment on flame soot: view from nanostructure and reactivity of soot

Effect of Precursors and Radiation on Soot Formation in Turbulent Diffusion Flame

Optimisation of the arc-discharge production of multi-walled carbon nanotubes