Abstract:The paper presents a technique to obtain an electrically-tunable matching between the series and parallel resonant frequencies of a piezoelectric MEMS acoustic transducer to increase the effectiveness of acoustic emission/detection in voltage-mode driving and sensing. The piezoelectric MEMS transducer has been fabricated using the PiezoMUMPs technology, and it operates in a plate flexural mode exploiting a 6 mm × 6 mm doped silicon diaphragm with an aluminum nitride (AlN) piezoelectric layer deposited on top. The piezoelectric layer can be actuated by means of electrodes placed at the edges of the diaphragm above the AlN film. By applying an adjustable bias voltage Vb between two properly-connected electrodes and the doped silicon, the d31 mode in the AlN film has been exploited to electrically induce a planar static compressive or tensile stress in the diaphragm, depending on the sign of Vb, thus shifting its resonant frequency. The working principle has been first validated through an eigenfrequency analysis with an electrically induced prestress by means of 3D finite element modelling in COMSOL Multiphysics®. The first flexural mode of the unstressed diaphragm results at around 5.1 kHz. Then, the piezoelectric MEMS transducer has been experimentally tested in both receiver and transmitter modes. Experimental results have shown that the resonance can be electrically tuned in the range Vb = ±8 V with estimated tuning sensitivities of 8.7 ± 0.5 Hz/V and 7.8 ± 0.9 Hz/V in transmitter and receiver modes, respectively. A matching of the series and parallel resonant frequencies has been experimentally demonstrated in voltage-mode driving and sensing by applying Vb = 0 in transmission and Vb = −1.9 V in receiving, respectively, thereby obtaining the optimal acoustic emission and detection effectiveness at the same operating frequency.

Piezoelectric Voltage Coupled Reentrant Cavity Resonator

Thermally Excited Micromechanical Vacuum Resonator

Self-Oscillating Calorimeter Based on Thermal-Piezoresistive Resonator

A Thermal-Piezoresistive Self-Sustained Resonant Mass Sensor with High-Q (>95k) in Air

Note: an in Situ Method for Measuring the Non-Linear Response of a Fabry-Perot Cavity.

Investigation of Deep-Sea Longitudinal Vibration Cavity Resonant Coupling Transducers Made of Relaxor Ferroelectric Single-Crystal Material

A Frequency Reconfigurable Microwave Reaction Cavity Based on a Quarter-Wave Coaxial Cavity Resonator

Piezoelectric MEMS Acoustic Transducer with Electrically-Tunable Resonant Frequency

Microwave cavity-enhanced transduction for plug and play nanomechanics at room temperature

Room temperature cavity electromechanics in the sideband-resolved regime

Micromanipulation transfer of membrane resonators for circuit optomechanics

Experimental Investigation of a Cavity-Mode Resonator Using a Micromachined Two-Dimensional Silicon Phononic Crystal in a Square Lattice

A microwave transducer for a nano mechnical resonator

Transient Phenomenon of Longitudinal Flexural Coupled Vibrations in a Small Rectangular Piezoelectric Ceramic Plate (8 Mm×2.16 Mm×1 Mm)

Multimode Strong Coupling in Superconducting Cavity Piezo-electromechanics

Multimode Strong Coupling in Superconducting Cavity Piezoelectromechanics.

Frequency-Reconfigurable Tm010-Mode Reentrant Cylindrical Cavity for Microwave Material Processing

A Novel Piezoelectric Resonator for Liquid Density and Viscosity Measurement

Coupling Capacitively Distinct Mechanical Resonators for Room-Temperature Phonon-Cavity Electromechanics.

Frequency Characteristics Testing Of Micromachined Resonant Pressure Sensor

Tunable MEMS cantilever resonators electrothermally actuated and piezoelectrically sensed