Abstract:Accurate measurements of the nanoscale electromechanical coupling in materials, including piezo and ferroelectrics, twisted 2D layers, and biological systems is of both fundamental scientific and applied importance. Piezoresponse Force Microscopy (PFM) is capable of detecting strains in these materials, down to the picometer range. Following the emergence of weaker materials, the smaller signals associated with them have revealed various crosstalk challenges that have limited the accuracy of measurements. Previous work demonstrated that the use of an interferometric displacement sensor (IDS) positioned appropriately above the tip of the cantilever (x/L~1), where x is the spot position and L is the cantilever length, has enabled sensitive and artifact-free electromechanical measurements. A similar approach has been employed in removing unwanted electrostatic and in-plane response contributions for the optical beam deflection (OBD) measurement technique commonly used in most atomic force microscopes. In the present study, extensive automated sub-resonance spot position dependent PFM measurements were conducted on periodically poled lithium niobate (PPLN). In this work, both IDS and OBD responses were measured simultaneously, allowing direct comparisons of the two approaches. The IDS showed a blind spot at x/L~1, as expected. However, for OBD measurements, the blind spot's location exhibited wider variation, ranging from 0.15<x/L<0.61. Furthermore, the magnitudes of the amplitudes measured with IDS and OBD were typically different, sometimes approaching disagreement by a factor of two. These measurements have important implications, not only for the PPLN measured here, but for more complex and unknown samples that have a heterogeneous polarization and electrical characteristic.

Note: an in Situ Method for Measuring the Non-Linear Response of a Fabry-Perot Cavity.

Observation of A Nonlinear Microfiber Resonator

Closed-loop Displacement Control System for Piezoelectric Transducer Based on Optical Frequency Comb

Nondestructive In-situ Permittivity Measurement of Liquid Within a Bottle Using an Open-Ended Microwave Waveguide

Non-contact Fiber Vibration Sensor based on Intracavity Modulation of an Extrinsic Fabry-Perot Interferometer

Fiber Acoustic Sensor with Stable Operating-Point Based on a Photo-Thermal Cavity

Comparison of Measurements with Finite-Element Analysis of Silicon-Diaphragm-Based Fiber-Optic Fabry–Perot Temperature Sensors

Stabilization of optical Fabry–Perot sensor by active feedback control of diode laser

Note: High-performance HeNe Laser Feedback Interferometer with Birefringence Feedback Cavity Scanned by Piezoelectric Transducer.

Subnanometer Absolute Displacement Measurement Using a Frequency Comb Referenced Dual Resonance Tracking Fabry-Perot Interferometer.

A Displacement Sensor Combining Cavity Tuning of A Laser with A Piezoelectric Transducer'S Subdivision Technique for A Bidirectional Sampling on the Rising and Falling Flanks

Fast interrogation of dynamic low‐finesse Fabry‐Perot interferometers: A review

Displacement Sensor Based on Intra-Cavity Tuning of Dual-Frequency Gas Laser

High Finesse Fiber Fabry-Perot Cavities: Stabilization and Mode Matching Analysis

Single-cavity loss-enabled nanometrology

Highly precise nonlinear error calibrating system based on Fabry-Perot interferometer - art. no. 68342X

Accurate Vertical Nanoelectromechanical Measurements

Compact fiber optical interferometer technique to measure picometer displacements in biological piezoelectric materials

Transfer matrix analysis of the birefringent fiber Fabry–Perot cavity and laser frequency locking

Extensible multi-wavelength interrogation method for arbitrary cavities in low-fineness multi-cavity Fabry-Pérot interferometric sensors

A Vibration Sensor Based on Fiber Bragg Grating Fabry-Perot Cavity