Abstract:In this paper, we report the numerical and experimental study on micromechanical resonators which are made by introducing defects on an otherwise perfect two-dimensional (2D) silicon phononic crystal (PnC) slab. The 2D PnC slab is made by etching a square array of cylindrical air holes in a free-standing silicon plate with a thickness of 10 µm, while the defects are created by reducing the radii of three rows of air holes at the centre of the 2D PnC slab. Three resonators with different values of reduced radii, i.e., 2 µm, 4 µm and 6 µm, are included in this study. The finite-element-modelling method is used to calculate the band structure of the perfect 2D PnC slab and to analyse the different mode shapes of the structure. The design, numerical modelling, fabrication process, as well as characterization results and discussions of the three PnC resonators are also included. Due to its CMOS-compatibility, aluminium nitride is chosen to be the piezoelectric material of the inter-digital transducers, which are used to generate and detect acoustic waves. Testing is done to characterize the resonant frequency (f), quality factor (Q), as well as insertion loss of each of the three microfabricated PnC resonators and the results are discussed by analysing the simulated transmission spectra, the defected band structures, and the steady-state displacement profiles of the structures at their respective resonant frequencies. The experimental results show that the designed PnC resonators with reduced central-hole radii have higher resonant frequency and higher quality factors as compared to their normal Fabry–Perot counterpart, thanks to the higher-frequency modes supported within the cavity and slow sound effect in the lateral direction introduced by the central holes with reduced radii, respectively. As a result, the achieved (f-Q) product can be as high as 2.96 × 1011, which is among the highest for silicon resonators operating in air.

Experimental Investigation of a Cavity-Mode Resonator Using a Micromachined Two-Dimensional Silicon Phononic Crystal in a Square Lattice

A Novel Micromechanical Resonator Using Two-Dimensional Phononic Crystal Slab

Micromechanical Resonators Based on Silicon Two-Dimensional Phononic Crystals of Square Lattice

Development of microfabricated phononic crystal resonators based on two-dimensional silicon slab

Numerical and experimental study on silicon microresonators based on phononic crystal slabs with reduced central-hole radii

Investigation on the optimized design of alternate-hole-defect for 2D phononic crystal based silicon microresonators

Silicon two-dimensional phononic crystal resonators using alternate defects

Experimental verification of phononic crystal slab based silicon microresonators

On‐Chip Tightly Confined Guiding and Splitting of Surface Acoustic Waves Using Line Defects in Phononic Crystals

Experimental demonstration of Fano resonance in microfabricated phononic crystal resonators based on two-dimensional silicon slab

Evidence on simultaneous improvement of motional impedance and Q-factor of silicon phononic crystal micromechanical resonators by variously engineering the cavity defects

Micromechanical Resonators Based on Two-dimensional Phononic Crystal Slabs

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

High-Q and High-Order Side-Coupled Air-Mode Nanobeam Photonic Crystal Cavities in Silicon

Localized Modes in Asymmetric Phononic Crystals

The investigation of point defect modes of phononic crystal for high Q resonance

A high Q micromachined single crystal silicon bulk mode resonator with pre-etched cavity

High- Q Photonic Crystal Cavity in a Single-Mode Silicon Ridge Waveguide

A High-Performance Bulk Mode Single Crystal Silicon Microresonator Based On A Cavity-Soi Wafer

A Precisely‐Controlled Multichannel Phononic Crystal Resonant Cavity

Phonon Lasing in a Hetero Optomechanical Crystal Cavity