Abstract:The paper presents a technique to obtain an electrically-tunable matching between the series and parallel resonant frequencies of a piezoelectric MEMS acoustic transducer to increase the effectiveness of acoustic emission/detection in voltage-mode driving and sensing. The piezoelectric MEMS transducer has been fabricated using the PiezoMUMPs technology, and it operates in a plate flexural mode exploiting a 6 mm × 6 mm doped silicon diaphragm with an aluminum nitride (AlN) piezoelectric layer deposited on top. The piezoelectric layer can be actuated by means of electrodes placed at the edges of the diaphragm above the AlN film. By applying an adjustable bias voltage Vb between two properly-connected electrodes and the doped silicon, the d31 mode in the AlN film has been exploited to electrically induce a planar static compressive or tensile stress in the diaphragm, depending on the sign of Vb, thus shifting its resonant frequency. The working principle has been first validated through an eigenfrequency analysis with an electrically induced prestress by means of 3D finite element modelling in COMSOL Multiphysics®. The first flexural mode of the unstressed diaphragm results at around 5.1 kHz. Then, the piezoelectric MEMS transducer has been experimentally tested in both receiver and transmitter modes. Experimental results have shown that the resonance can be electrically tuned in the range Vb = ±8 V with estimated tuning sensitivities of 8.7 ± 0.5 Hz/V and 7.8 ± 0.9 Hz/V in transmitter and receiver modes, respectively. A matching of the series and parallel resonant frequencies has been experimentally demonstrated in voltage-mode driving and sensing by applying Vb = 0 in transmission and Vb = −1.9 V in receiving, respectively, thereby obtaining the optimal acoustic emission and detection effectiveness at the same operating frequency.

Tunable MEMS cantilever resonators electrothermally actuated and piezoelectrically sensed

On-Chip Electro-Optic Tuning of A Lithium Niobate Microresonator with Integrated In-Plane Microelectrodes

Resonant Frequency Tunable Silicon Fishbone-Shaped MEMS Double Ended Tuning Fork.

Piezoelectric MEMS Acoustic Transducer with Electrically-Tunable Resonant Frequency

Quasi-linear Frequency Tuning for CMOS-MEMS Resonators

Tunable Micro- and Nanomechanical Resonators

Experimental Demonstration of Thermally Tunable Fano and EIT Resonances in Coupled Resonant System on SOI Platform

Tunable Terahertz Metamaterial with Electromagnetically Induced Transparency Characteristic for Sensing Application

Enhancing responsivity and detection limit in tunable nano-electromechanical system resonator mass sensors

Miniaturized Multi-Cantilever MEMS Resonators with Low Motional Impedance

Tunable mechanical coupling between driven microelectromechanical resonators

Ultra-tuning of nonlinear drumhead MEMS resonators by electro-thermoelastic buckling

Electrical readout/characterization of single crystal diamond (SCD) cantilever resonators

A Mode-Selectable Beam Resonator Based on Sectionalized Electrodes

A MEMS Fishbone-Shaped Electrostatic Double-Ended Tuning Fork Resonator with Selectable Higher Modes

Optomechanical transduction of an integrated silicon cantilever probe using a microdisk resonator

Actuation Dependency of Frequency Tuning in MEMS Resonators

Thermal tuning of mechanical nonlinearity in GaAs doubly-clamped MEMS beam resonators

On-chip frequency tuning of fast resonant MEMS scanner

High- Integrated CMOS-MEMS Resonators With Deep-Submicrometer Gaps and Quasi-Linear Frequency Tuning

Microelectromechanical system cantilever-based frequency doublers