Frequency Characteristics Testing Of Micromachined Resonant Pressure Sensor

Cg Cai,Sc Fan
2004-01-01
Abstract:A new micromachined resonant pressure sensor has been successfully designed and fabricated. It is driven electrothermally and the relevant vibration of the micro resonator, resonant beam, sensed by a piezoresistor. In order to test the resonant frequency and the Q factor of the resonator, a frequency characteristics testing system of micromachined resonant sensors is developed. Because of the micro structure, the output signal of the sensor is very small, about several X, and submerged by noise and interference. So a phase lock-in amplifier is employed to detect the micro signal. Two kinds of testing methods, the stable frequency scanning method and the dynamic frequency scanning method, are introduced in this paper. The stable frequency scanning method adopts sinusoidal signal to excite the resonator, its responding signal is detected in its stable vibrating state, thus the frequency characteristic on the relevant frequency is obtained. The dynamic frequency scanning method adopts chirp signal to excite the resonator, its responding signal is acquired at the same time, then the frequency characteristics of the resonator can be calculated. Testing results indicate that the resonant frequency of the resonator is about 42.5 kHz, and the Q factor about 300 in air.
What problem does this paper attempt to address?