Abstract:Highly delithiated LiCoO2 has high specific capacity (>200 mAh g–1); however, its degradation behavior causes it to have poor electrochemical performance and thermal instability. The degradation of highly delithiated LiCoO2 is mainly induced by oxygen vacancy migration and weakening of oxygen-related interactions, which result in pitting corrosion and fault formation on the surface. In this research, a coupling agent, namely, 3-aminopropyltriethoxysilane (APTES), was grafted onto the surface of LiCoO2 to form a cross-linking structure. Through the aza-Michael addition reaction, an oligomer formed from barbituric acid and bisphenol a diglycidyl ether diacrylate were reacted with the cross-linking APTES to form an artificial cathode electrolyte interphase (ACEI). The highly delithiated LiCoO2 containing the ACEI had considerably less degradation on the surface of the bulk material caused by oxygen release. The formation of the O1 phase was prevented in high delithiation and high-temperature operations. This research revealed that the ACEI reinforced the Co–O bond, which is crucial in preventing gas evolution and O1 phase formation. In addition, the ACEI prevents direct contact between the electrolyte and highly active surface of LiCoO2, thereby preventing the formation of a thick and high impedance traditional cathode electrolyte interphase. According to the present results, highly delithiated LiCoO2 containing the ACEI exhibited outstanding cycle retention and capacity at 55 °C as well as low heat capacity release in the fully delithiated state. The ACEI considerably protected and maintained the electrochemical performance of highly delithiated LiCoO2, which is suitable for high-energy-density applications, such as electric vehicles and power tools.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c13523.Additional experimental details, reaction mechanism of APTES/oligomer on LiCoO2, EDS of 2, TEM of the three materials, XPS of fresh/cycled oligomer-coated LiCoO2, and battery performance at delithiated voltages of 4.6/4.7 V (PDF)This article has not yet been cited by other publications.

In Situ Co–O Bond Reinforcement of the Artificial Cathode Electrolyte Interphase in Highly Delithiated LiCoO 2 for High-Energy-Density Applications

A compact interphase involving reversible redox couple stabilizes 4.6 V LiCoO2 cathode

Synergistical Stabilization of Li Metal Anodes and LiCoO 2 Cathodes in High-Voltage Li∥LiCoO 2 Batteries by Potassium Selenocyanate (KSeCN) Additive

Channelization of cathode/electrolyte interphase to enhance the rate-capability of LiCoO2

Ultra-thin and Mechanically Stable LiCoO2-Electrolyte Interphase Enabled by Mg2+ Involved Electrolyte

Structure/Interface Coupling Effect for High‐Voltage LiCoO2 Cathodes

Lattice Engineering on Li 2 CO 3 ‐Based Sacrificial Cathode Prelithiation Agent for Improving the Energy Density of Li‐Ion Battery Full‐Cell

Structure/Interface Coupling Effect for High‐Voltage LiCoO2 Cathode

Structure/Interface Coupling Effect for High‐Voltage LiCoO<sub>2</sub> Cathodes

Densification of Cathode/Electrolyte Interphase to Enhance Reversibility of LiCoO2 at 4.65 V

Lattice‐Matched Interfacial Modulation Based on Olivine Enamel‐Like Front‐Face Fabrication for High‐Voltage LiCoO2

Surface-interspersed nanoparticles induced cathode-electrolyte interphase enabling stable cycling of high-voltage LiCoO 2

Building interface bonding and shield for stable Li-rich Mn-based oxide cathode

Tuning Surface Reconfiguration for Durable Cathode/Electrolyte Interphase of LiCoO2 at 45 °C

Evolution of Ternary LixSnyOz Artificial Cathode-Electrolyte Interphase (ACEI) Through ALD: a Surface Strengthened NCM811 with Enhanced Electrochemical Performances for Li-ion Batteries

Preventing the Distortion of CoO6 Octahedra of LiCoO2 at High-Voltage Operation of Lithium-Ion Battery: An Organic Surface Reinforcement

<i>In</i><i>-situ</i> constructed protective bilayer enabling stable cycling of LiCoO<sub>2</sub> cathode at high-voltage

Densification of Cathode/Electrolyte Interphase to Enhance Reversibility of LiCoO<sub>2</sub> at 4.65 V

In-Situ Constructed Protective Bilayer Enabling Stable Cycling of LiCoO 2 Cathode at High-Voltage

High‐Entropy Surface Complex Stabilized LiCoO2 Cathode

Mechanochemically Robust LiCoO<sub>2</sub> with Ultrahigh Capacity and Prolonged Cyclability