Abstract:Most of the tracking detectors for high energy particle experiments are filled with silicon detectors since they are radiation hard, they can give very small spatial resolution and they can take advantage of the silicon electronics foundries developments and production lines. Strip detectors are very useful to cover large areas for tracking purposes, while consuming less power per area compared to pixel sensors. The majority of particle physics experiments use conventional silicon strip detectors fabricated in foundries that do not use stitching, relying on a very small number of foundries worldwide that can provide large amounts of strip detectors. Fabricating strip detectors in a CMOS foundry opens the possibility to use more foundries and to include active elements in the strips for future productions. For the passive CMOS strip detectors project we fabricated strip detectors in a CMOS foundry using two 1 cm2 reticles that are stitched together along the wafer. The fabricated strips stitched the reticles three and five times, and it was shown that the performance of those strips is not affected by the stitching. This paper shows 3D TCAD simulations of the stitching area to investigate the possible effects stitching can have on the performance of the strip detectors, considering different stitching mismatches. We will show that the mismatch of stitched structures up to 1 um does not impact the performance with TCAD simulations which agrees with the results obtained from the measurements.

Using the cathode surface of straw tube for measuring the track coordinates along the wire

2-D straw detectors with high rate capability

The use of segmented cathode of a drift tube for designing a track detector with a high rate capability

A New Laser Displacement Sensor Based on Triangulation for Gauge Real-Time Measurement

Realization and Test of Position Sensitive Boron Coated Straw-Tube

Design and optimization of a new type of contactless radial C4D sensor

Development of high granulated straw chambers of large sizes

Longitudinal tension and mechanical stability of a pressurized straw tube

Studies of the effect of rate on gain for straw tube detector

Numerical Studies of Straw Tube Detectors

Development and property study of the $12 μ$m thick straw tubes with a diameter of 5 mm for the COMET Straw Tracker System

Operating mode of high pressure straws with high spatial resolution

Development of 10 m Hodoscope Made of Drift Tubes for Cosmic Ray Muon Registration

A multiplex readout method for position sensitive boron coated straw neutron detector

The Straw Tube Trackers of the PANDA Experiment

A Panel Prototype for the Mu2e Straw Tube Tracker at Fermilab

Simple acoustical technique for automated measurement of drift tube anode wire tension

A Study Of The Calibration Of Wire Positions For The Besiii Drift Chamber Using Physics Data Without Magnetic Field

Study of A Multi-Wire Proportional Chamber with A Cathode Strip and Delay-Line Readout

TCAD Simulation of Stitching for Passive CMOS Strip Detectors

Study on digital-analog rod position detector