Abstract:The actuator system of a hard disk drive (HDD) is very sensitive to vibration circumstances. It is of great importance to study the dynamic characteristics of the actuator system and to control its vibration response. Piezoelectric shunt damping is an emerging vibration suppression technique used to control structural vibration. In this paper, two methods are proposed to improve vibration damping efficiency of the classical piezoelectric shunt damping system and suppress the vibration of the actuator arm. Based on the analysis of the effect of the generalized electromechanical coupling coefficient on the amplitude of the transfer function and damping ratio, the distribution area of the PZT transducer of the shunt damping system is defined as a design variable of topology optimization to maximize the effective area and hence to maximize the converted vibration energy of the actuator arm. Moreover, the vibration control efficiency is improved by introducing a negative impedance converter to eliminate the additional loss resistance of the coil inductor of the shunt circuit. Then the vibration control experiments for the actuator arm of an HDD are carried out to verify the proposed methods. According to the results of FE analysis and modal tests of the actuator system, topology optimization for the PZT transducer is performed on the target modes while the effects of additional stiffness and additional mass of the coupled PZT transducer are also considered. The high damping efficiency of this improved piezoelectric shunt damping system is demonstrated by a 323% maximum increment of damping ratio and 20.36 dB, 8.22 dB and 12.02 dB reduction for its three modes of vibration, respectively.

Vibration suppression of a cylindrical shell structure by transmission path control

Fuzzy Controller For Active Vibration Control Of Cylindrical Shells

Experiment on Active Vibration Isolation of a Conical Shell Isolator

Spatially Filtered Vibration Control of Cylindrical Shells

Multi-channel Active Vibration Isolation for the Control of Underwater Sound Radiation from A Stiffened Cylindrical Structure: A Numerical Study

Application of Bolt Vibration Isolation Structure in Torpedo Noise Control

Active Vibration Suppression of Payloads with a Conical Isolator

Vibration Control of Toroidal Shells with Parallel and Diagonal Piezoelectric Actuators

Study and Simulation of Active Vibration Isolation System with Piezo Electric Stack Actuators

Theoretical analysis of a multi-layered thin shell coupled with piezoelectric shell actuators for distributed vibration controls

Vibration Suppression Of A Hard Disk Driver Actuator Arm Using Piezoelectric Shunt Damping With A Topology-Optimized Pzt Transducer

Vibration and Damping Characteristics of Cylindrical Shells with Active Constrained Layer Damping Treatments

Active/passive vibration isolation with multi-axis transmission control: Analysis and experiment

Active Vibration Control of Rotating Carbon Nanotube Reinforced Composite Cylindrical Shells Via Piezoelectric Patches

Research on active vibration control of piezoelectric composite shells

A novel active and passive integrated vibration isolator based on piezoelectric stack: Characteristic analysis and experimental investigation

Simulation and Experiment on Lateral Vibration Transmission Control of a Shafting System with Active Stern Support

Active and Passive Control Research on Attenuation and Isolation Vibration of Sonar Platform

Design of Vibro-acoustic Control of the Cylindrical Shell via a Dynamic Vibration Absorber Annulus

Lateral Vibration Transmission Suppression of a Shaft-Hull System with Active Stern Support

Experimental Investigation on Vibration Isolation Effectiveness of Two Sets of Underwater Vehicle Dynamic Systems