Abstract:Direct Instantaneous Torque Control (DITC) with an adaptive turn‐on angle technique is presented in this paper to improve the torque ripple of Switched Reluctance Motor (SRM) for Electric Vehicle applications. An improved DITC switching scheme is presented by adopting two switching modes in the commutation region to reduce the torque ripples. A closed‐loop turn‐on controller is developed to improve system efficiency by driving the incoming current to its first peak at the instant the transition between the switching modes takes place. Direct Instantaneous Torque Control (DITC) with an adaptive turn‐on angle technique is presented in this paper to improve the torque ripple of the Switched Reluctance Motor (SRM) for Electric Vehicle applications. Torque ripple suppression is achieved by employing two operating modes during the commutation interval. First, both the outgoing and incoming phase states are modified to track the required torque during the incoming phase's minimum inductance area. As soon as the incoming phase leaves its minimum inductance zone, the outgoing phase is demagnetised, and only the incoming phase state is modified for torque tracking. In addition, a closed‐loop regulator is used to dynamically control the turn‐on angle that drives the incoming current to reach its first peak at the instant of switching between the two operation modes when the rotor and stator poles initiate overlap, thus increasing the motor's efficiency. Simulation results showed that the proposed control method has superior advantages over the traditional DITC and Average Torque Controller. Furthermore, the simulation results were verified experimentally using a four‐phase 4kW, 8/6 SRM prototype.

A new flux and multilevel hysteresis torque band DTC with lookup table‐based switched reluctance motor drive to suppress torque ripple

Investigation Of Direct Torque Control And Torque Sharing Function Strategy For Switched Reluctance Motor Applications

Optimized Direct Instantaneous Torque Control for SRMs With Efficiency Improvement

Multi-level Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

Torque ripple minimization for switched reluctance motors by online modification of torque sharing function

A Novel Boost Chopper Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

Sliding-mode Torque Distribution Control of SRM

A Novel Dead-Beat Torque Control of Switched Reluctance Machines

Torque Ripple Minimization of Switched Reluctance Motor Based on Iterative Learning Control

Experimental analysis of enhanced finite set model predictive control and direct torque control in SRM drives for torque ripple reduction

A Novel Duty-Controlled DTC of a Surface PMSM Drive With Reduced Torque and Flux Ripples

A Novel Sliding Hysteresis Band Based Direct Torque Control Scheme for PMSM Motors to Achieve Improved Current THD With Reduction in Torque and Flux Ripples Eliminating the Low-Speed Problems

Improved Torque Ripple of Switched Reluctance Motors using Sliding Mode Control for Electric Vehicles

Torque ripple reduction of switched reluctance motor using direct instantaneous torque control and adaptive turn‐on technique for electric vehicle applications

Direct Instantaneous Torque Control of Srm Based on New Flux Linkage Detection Method

Optimum Design of Switched Reluctance Motor Based on Direct Instantaneous Torque Control

Overview of the Direct Torque Control Strategy in Switched Reluctance Motor Drives

An Improved Direct Instantaneous Torque Control Based on Adaptive Terminal Sliding Mode for a Segmented-Rotor SRM

Research on Torque Ripple Minimization Strategy for Direct Torque Control of Induction Motors

Torque Ripple Suppression Method of Switched Reluctance Motor Based on an Improved Torque Distribution Function

Flux-Linkage Loop-Based Model Predictive Torque Control for Switched Reluctance Motor