Abstract:Direct Instantaneous Torque Control (DITC) with an adaptive turn‐on angle technique is presented in this paper to improve the torque ripple of Switched Reluctance Motor (SRM) for Electric Vehicle applications. An improved DITC switching scheme is presented by adopting two switching modes in the commutation region to reduce the torque ripples. A closed‐loop turn‐on controller is developed to improve system efficiency by driving the incoming current to its first peak at the instant the transition between the switching modes takes place. Direct Instantaneous Torque Control (DITC) with an adaptive turn‐on angle technique is presented in this paper to improve the torque ripple of the Switched Reluctance Motor (SRM) for Electric Vehicle applications. Torque ripple suppression is achieved by employing two operating modes during the commutation interval. First, both the outgoing and incoming phase states are modified to track the required torque during the incoming phase's minimum inductance area. As soon as the incoming phase leaves its minimum inductance zone, the outgoing phase is demagnetised, and only the incoming phase state is modified for torque tracking. In addition, a closed‐loop regulator is used to dynamically control the turn‐on angle that drives the incoming current to reach its first peak at the instant of switching between the two operation modes when the rotor and stator poles initiate overlap, thus increasing the motor's efficiency. Simulation results showed that the proposed control method has superior advantages over the traditional DITC and Average Torque Controller. Furthermore, the simulation results were verified experimentally using a four‐phase 4kW, 8/6 SRM prototype.

Optimum Design of Switched Reluctance Motor Based on Direct Instantaneous Torque Control

Investigation Of Direct Torque Control And Torque Sharing Function Strategy For Switched Reluctance Motor Applications

Optimized Direct Instantaneous Torque Control for SRMs With Efficiency Improvement

Multi-level Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

Design and Torque Optimization of Single-phase Hybrid Switched Reluctance Motors

Optimum Control for Switched Reluctance Motor Using Iterative Learning

Torque ripple minimization for switched reluctance motors by online modification of torque sharing function

A high efficiency direct instantaneous torque control of SRM using commutation angles control

A High Efficiency Torque Control Method of Switched Reluctance Motors Using Low Loss Commutation Control

Torque Ripple Minimization of Switched Reluctance Motor Based on Iterative Learning Control

Sliding-mode Torque Distribution Control of SRM

A Novel Boost Chopper Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

Direct Instantaneous Torque Control of Srm Based on New Flux Linkage Detection Method

A Simple Strategy for Parameters Identification of SRM Direct Instantaneous Torque Control

Low-Cost Direct Instantaneous Torque Control for Switched Reluctance Motors with Bus Current Detection under Soft-Chopping Mode

An Improved Direct Instantaneous Torque Control Based on Adaptive Terminal Sliding Mode for a Segmented-Rotor SRM

A novel direct torque control method for switched reluctance motors based on optimal turn-on angle

Design and control of a 48/36 switched reluctance motor for high performance direct-drive applications.

Direct instantaneous torque control of switched reluctance motor based on adaptive backstepping

Torque ripple reduction of switched reluctance motor using direct instantaneous torque control and adaptive turn‐on technique for electric vehicle applications

A NEW TORQUE CONTROL METHOD FOR SWITCHED RELUCTANCE MOTORS