Abstract:In this study we report on the film growth and characterization of thin (approximately 50 nm thick) Ti-Fe-C films deposited on amorphous quartz. The experimental studies have been complemented by first principles density functional theory (DFT) calculations. Upon annealing of as-prepared films, the composition of the metastable Ti-Fe-C film changes. An iron-rich phase is first formed close to the film surface, but with increasing annealing time this phase is gradually displaced toward the film-substrate interface where its position stabilizes. Both the magnetic ordering temperature and the saturation magnetization changes significantly upon annealing. The DFT calculations show that the critical temperature and the magnetic moment both increase with increasing Fe and C-vacancy concentration. The formation of the metastable iron-rich Ti-Fe-C compound is reflected in the strong increase of the magnetic ordering temperature. Eventually, after enough annealing time ($\geq 10$ minutes), nano-crystalline $\alpha$-Fe starts to precipitate and the amount and size of these precipitates can be controlled by the annealing procedure; after 20 minutes of annealing, the experimental results indicate a nano-crystalline iron-film embedded in a wear resistant TiC compound. This conclusion is further supported by transmission electron microscopy studies on epitaxial Ti-Fe-C films deposited on single crystalline MgO substrates where, upon annealing, an iron film embedded in TiC is formed. Our results suggest that annealing of metastable Ti-Fe-C films can be used as an efficient way of creating a wear-resistant magnetic thin film material.

Carbon defect induced evolution of structural and mechanical properties in substoichiometric (HfMoNbZr)C x films

Molecular Dynamics Investigation of Metastable Structure and Hybridization Bond Evolution in High-Entropy CoCrFeNi Heterostructured Amorphous Carbon Films

The significant influence of carbon content on mechanical and thermal properties of (VNbTaMoW)0.5Cx high entropy carbides

Effect of C additions to the microstructure and wear behaviour of CoCrFeNi high-entropy alloy

Effects of the carbon-to-nitrogen ratio on the microstructure and properties of (CrNbSiTiZr)CxNy high-entropy carbonitride films

Structure and Mechanical Properties of A-C/(Alcrwtatinb)Cxny Composite Films

From single high-entropy phase to multi-phase transition: Microstructural evolution of multi-component carbide (ZrHfVNbMoW)C realized by adjusting Hf content and temperature

Unusual Deformation-Induced Martensitic Transformation in Fe-Co-Ni- Cr-Mn High Entropy Alloy Thin Films

Structure Evolution and Mechanical Properties of Ta–Nb–Ti–W–N Multielement Films

Microstructure evolution and mechanical properties of NbHfTiVCx novel refractory high entropy alloys with variable carbon content

Structural evolutions and mechanical behaviours of carbides in Nb-Ti-C alloys

Carbon Effect on Tensile and Wear Behaviors for a Dual-Phase Fe61.5 Cr17.5ni13al8 Alloy

Grain Refinement and FCC Phase Formation in AlCoCrFeNi High Entropy Alloys by the Addition of Carbon

Structure, mechanical, tribological properties and corrosion resistance of C/N dual doping Mo-S-C-N films

Effect of Mo and C Additions on Eta Phase Evolution of WC-13Co Cemented Carbides

Effect of carbon content on microstructure, hardness and wear resistance of CoCrFeMnNiCx high-entropy alloys

A novel wear-resistant magnetic thin film material based on a $Ti_{1-x}Fe_xC_{1-y}$ nanocomposite alloy

Achieving low wear in a complex concentrated alloy CrFeNiNb with multi-phase hierarchical microstructure

Enhancing wear resistance: In-situ ceramic phase precipitation for strengthening and toughening FeCoNiCrNx high-entropy alloy films

Metastable hybridized structure transformation in amorphous carbon films during friction—A study combining experiments and MD simulation

Effect of C addition on microstructure and mechanical properties of as-cast HEAs (Fe50Mn30Co10Cr10)100-xCx