Abstract:High-entropy alloys (HEAs) are novel multi-element alloys based on five or more constituent elements in a range of 5–35 at%. Here we present a method to improve strength of a body-centered cubic (bcc) matrix HEA without loss of ductility. The improvement was achieved by phase modulation combined other strengthening effect of interstitial carbon addition. Carbon addition can enhance strength and retain good ductility in some steels because carbon increases the volume fraction of face-centered cubic (fcc) phase. We used the same principle to design and fabricate a set of Al8(FeCuCrMn)92Cx (x = 0, 1, 2, 3, 4 at%) HEAs under near-rapid solidification. Our results showed that carbon addition modulated constituent phases by increasing the volume fraction of fcc phase and carbides. As a result, addition of carbon increased yield strength of this bcc matrix HEA. But the ductility decreased, especially when carbon content was higher than 3 at%, which was ascribed to uneven distribution of Cu-rich fcc phase and carbides precipitated in bcc phase region. After annealing at 1173 K for 2 h, addition of 1 at% carbon improved yield strength without compressive fracture. It demonstrated that a proper carbon content addition with annealing can enhance the yield strength without loss of ductility for this bcc matrix HEA. Thus, interstitial carbon addition is a meaningful method to improve the mechanical properties by phase modulation combined other strengthening effect.Graphic Carbon addition can increase the fraction of fcc phase and yield strength via phase modulation.The reduction of ductility is ascribed to uneven distribution of Cu-rich fcc phase and formation of carbides when the content of carbon is higher than 3 at%.Addition of 1 at% carbon with annealing can achieve the improvement of yield strength without loss of ductility.

Effect of C addition on microstructure and mechanical properties of as-cast HEAs (Fe50Mn30Co10Cr10)100-xCx

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Microstructural Evolution and Mechanical Properties of Al0.3CoCrFeNiSix. High-Entropy Alloys Containing Coherent Nanometer-Scaled Precipitates

Influences of Si and C addition on microstructure and mechanical properties of Fe2.5CoNiCu high-entropy alloy

Effect of C additions to the microstructure and wear behaviour of CoCrFeNi high-entropy alloy

Enhancing the Strength of AlCrFeNi HEAs Via Tailoring Aluminum Content and Optimal Aging Treatment

The Influence of Cr Addition on the Microstructure and Mechanical Properties of Fe-25Mn-10Al-1.2C Lightweight Steel

Microstructures and properties of Fe1.25CoNi1.25CrxAl0.25 high-entropy alloys after cold-rolling and annealing

Effect of Al content on microstructure and mechanical properties of as-cast AlxFeMnNiCrCu0.5 high-entropy alloys

Effect of carbon alloying on microstructure and mechanical behaviors of Fe35Ni35Cr20Mn10 multi-component alloy

Effect of Al Additions and Cooling Rate on the Microstructure and Mechanical Properties of Austenite FeMnAlC Steels

Improving Mechanical Properties of Co-Cr-Fe-Ni High Entropy Alloy via C and Mo Microalloying

Effects of Al Addition on the Microstructure and Mechanical Property of AlxCoCrFeNi High-Entropy Alloys

Microstructural evolution and mechanical behavior of Co‐free (Fe40Ni30Cr20Al10)100‐x Ti x high‐entropy alloys

Effect of alloying content on microstructure and mechanical properties of Fe–Mn–Al–C low-density steels

Microstructure, mechanical properties and deformation behavior of Cr-containing triplex low-density steels with different C content

Improvement on Mechanical Properties of a bcc Matrix Al8(FeCuCrMn)92 High-Entropy Alloy by Phase Modulation of Interstitial Carbon Element

Carbon Effect on Tensile and Wear Behaviors for a Dual-Phase Fe61.5 Cr17.5ni13al8 Alloy

Effects of Cr Content on Microstructure and Mechanical Properties of Co-Free FeCryNiAl0.8 High-Entropy Alloys

Effect of Co on phase stability and mechanical behavior of CoxCrFeNiMnAl0.3 high entropy alloys with micro/nano hierarchical structure

Influences of Ti additions on the microstructure and tensile properties of AlCoCrFeNi2.1 eutectic high entropy alloy