Abstract:High dielectric loss is a major drawback in CCTO-based electroceramics, and such high dielectric loss supports good microwave coupling for microwave synthesis of ceramics. Al substitution at Ti site and presence of moderate amount of secondary CuO intergranular melt-like phase can improve the dielectric properties of the ceramics. Therefore, microwave-assisted solid-state reaction was used to synthesize polycrystalline CaCu3Ti4−xAlxO12 (x = 0, 0.025, 0.05, 0.075, 0.1) ceramics. Lattice parameters and different amount of CuO phase were extracted from X-ray diffraction data via Rietveld refinement. Presence of grains with different morphology, and different kind of interfaces were confirmed through microstructure evolution. An approximate elemental analysis was revealed through selective area EDX. Variations in dielectric and impedance properties with frequency and temperature were investigated as an effect of Al3+ substitution at Ti4+ sites and appearance of secondary CuO phase. Maximum dielectric constant (εr) ~ 23,000 with ‘tan δ’ ~ 0.076 at 100 Hz has been observed for x = 0.05 ceramics at room temperature. Equivalent electrical circuits were proposed to understand the contributions arising from different electrically heterogeneous portions of CCTO-based ceramics. An elementary theoretical framework, based on different grains and interfaces (boundaries), has been proposed to understand the improved dielectric properties. Activation energies were calculated from imaginary part of impedance (Z″) and modulus (M″) functions and the values were in close agreement with activation energies associated to oxygen vacancies. In addition, defect chemistry has been discussed to understand the appearance of CuO phase as melt and the improvement of dielectric loss.

A novel route to lower the dielectric loss in CaCu$_{3}$Ti$_{4}$O$_{12}$ ceramics

Decrease of Dielectric Loss in CaCu3Ti4O12 Ceramics by La Doping

Decrease of Dielectric Loss in Giant Dielectric Constant CaCu3 Ti4 O12 Ceramics by Adding CaTiO3

Pressure Induced Dielectric Constant Suppression In Cacu3ti4o12 Ceramics

Reduction of the sintering temperature and dielectric loss of the CCTO ceramic by doping tellurite glass

Grain-boundary and subgrain-boundary effects on the dielectric properties of CaCu<sub>3</sub>Ti<sub>4</sub>O<sub>12</sub> ceramics

Ti deficiency effect on the dielectric response of CaCu3Ti4O12 ceramics

Enhanced breakdown strength and dielectric loss of Ca1−3x/2EuxCu3Ti4O12 ceramics prepared by polymer pyrolysis

Observation of giant dielectric constant in CdCu3Ti4O12 ceramics

Anti-reduction of Ti4+ and improved quality factor in Cu-doped Ca0.61Nd0.26TiO3 ceramics

The Effect of TiO2 on the Dielectric Performance of ZrO2 and Nb2O5 Pre-Doped CaCu3Ti4O12 Ceramics

Strontium doped CaCu3Ti4O12 ceramics with very low dielectric loss synthesized by the sol–gel method

Optimization of dielectric loss in calcium copper titanate based on different doping modification strategies

CaCu3Ti4O12 (CCTO) ceramics for capacitor applications

Enhanced dielectric properties and improved thermal stability in TiO 2 -based ceramics by Cu and Nb co-doping

Enhancement of Giant Dielectric Response in CaCu3Ti4O12 Ceramics by Zn Substitution

Influence of zinc on electrical and microstructural properties of CaCu 3Ti 4O 12 ceramics prepared by sol-gel process

Raman and Dielectric Spectra of Cacu3ti3.9o12 Ceramics

Research Progress in High Dielectric Constant Ceramic Material CaCu_3Ti_4O_(12)

Abnormal Dielectric Behaviors in Mn-Doped Cacu3ti4o12 Ceramics and Their Response Mechanism

Effect of Al substitution and secondary CuO phase on dielectric response in microwave-processed CaCu3Ti4−xAlxO12 ceramics