Abstract:Cu2O is one of the few transition metal oxides which can exhibit p–type conductivity due to native acceptor defects. Further improvements in the p–type conductivity of Cu2O can be achieved via extrinsic doping and post–growth processing. In this work, we investigate the effects of Ni doping in Cu2O with Ni content up to ∼11%. A variety of analytical techniques were utilized to investigate the structural, optical and electrical properties of these alloy thin films. We find that the incorporation of Ni improves the p–type conductivity of the films without altering the Cu2O crystallographic structure and maintains a wide bandgap of ∼2.5 eV. X–ray photoelectron spectroscopy (XPS) measurements reveal that the Fermi level moves closer to the valence band with increasing x, in agreement with the increasing hole concentration. Significant improvement in the crystallinity as well as the p–type conductivity of the alloy films can be observed after rapid thermal annealing (RTA). In particular, alloys with x≥0.005 exhibit a high hole mobility µ∼12–22 cm2/V-s with low resistivity of ρ∼30–60 Ω-cm and free hole concentration N∼1×1016 cm-3 after RTA in air–N2 ambient at 700°C. Such improvement can be attributed to the formation of Cu vacancies which promotes Ni substitution in the presence of small amount O2 in the air–N2 annealing environment. Finally, we fabricated a transparent p–(NixCu1-x)2O/n–ZnO heterojunction and evaluated its junction performance. XPS measurements reveal a type II band offset of this heterojunction with valence band and conduction band offsets of 2.81 eV and 2.07 eV, respectively. The heterojunction exhibits both rectification and photovoltaic response, demonstrating its potential for p–n junction and photodetection devices.

N-type In (or Al) doped Cu2O thin films by magnetron sputtering

Fabrication and Properties of Pure-Phase Cu2O Co-Doped with Zinc and Indium

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Zn-Doped Cuals(2) Transparent P-Type Conductive Thin Films Deposited By Pulsed Plasma Deposition

Pulsed laser deposition of single phase n- and p-type Cu2O thin films with low resistivity

Improving the p–type conductivity of Cu2O thin films by Ni doping and their heterojunction with n–ZnO

Properties of Al-doped ZnS Films Grown by Chemical Bath Deposition

P -Type Conduction in N–Al Co-Doped ZnO Thin Films

Properties of Al-doped Copper Nitride Films Prepared by Reactive Magnetron Sputtering

Nitrogen Plasma-Assisted Codoped P-type (In, N):SnO(2) Ultra-Fine Thin Films and N-ZnO/p-In:SnO(2) Core-Shell Heterojunction Diodes Fabricated by an Ultrasonic Spray Pyrolysis Method

p-Type conduction in Al–N co-doped ZnO films

Investigating the MgAl-Doping N-Type ZnO(MgAlZnO) Metal Oxide Film Used As the ITO Cathode Buffer Layer in the Inverted Polymer Solar Cell

Optimal n-Type Al-Doped ZnO Overlayers for Charge Transport Enhancement in p-Type Cu2O Photocathodes

Oxide phase and conductivity-type of copper oxide thin films deposited by direct current magnetron sputtering

First Principles Study on Band Structure and Optical Properties of N-doped CuAlO2

Cu2o Homojunction Solar Cells: F-Doped N-Type Thin Film and Highly Improved Efficiency

Highly Enhanced P-Type Electrical Conduction in Wide Band Gap Cu1+xAl1−xS2 Polycrystals

Photocatalysis, wettability and optical properties of N-doped Cu2O/CuO thin films for smart coating applications

Alkali Metals Doped Cu0.94A0.06O (A = Li, Na and K) Thin Films: Facile Synthesis, Structural, Optical and Thermoelectric Properties

Growth of Zn doped Cu(In, Ga)Se 2 thin films by RF sputtering for solar cell applications

Achieve p -type conduction in N-doped and (Al,N)-codoped ZnO thin films by oxidative annealing zinc nitride precursors