Abstract:The thermoelectric performance of the p‐type Mg3Sb2‐based compound is improved by fully optimizing its carrier concentration, mobility, and lattice thermal conductivity. As a result, a unicouple comprised of p‐type Mg1.594Yb0.2Na0.006Zn1.2Sb2 and n‐type Mg3.2SbBi0.99Te0.01 is successfully constructed, and exhibits high conversion efficiency, good stability, and low cost, showing its great potential for low‐grade heat recovery. Bi2Te3‐based devices have long dominated the commercial market for thermoelectric cooling applications, but their narrow operating temperature range and high cost have limited their possible applications for conversion of low‐grade heat into electric power. The recently developed n‐type Mg3Sb2‐based compounds exhibit excellent transport properties across a wide temperature range, have low material costs, and are nontoxic, so it would be possible to substitute the conventional Bi2Te3 module with a reliable and low‐cost all‐Mg3Sb2‐based thermoelectric device if a good p‐type Mg3Sb2 material can be obtained to match its n‐type counterpart. In this study, by comprehensively regulating the carrier concentration, carrier mobility, and lattice thermal conductivity, the thermoelectric performance of p‐type Mg3Sb2 is significantly improved through Na and Yb doping in Mg1.8Zn1.2Sb2. Moreover, p‐ and n‐type Mg3Sb2 are similar in terms of their coefficients of thermal expansion and their good performance stability, thus allowing the construction of a reliable all‐Mg3Sb2‐based unicouple. The decent conversion efficiency (≈5.5% at the hot‐side temperature of 573 K), good performance stability, and low cost of this unicouple effectively promote the practical application of Mg3Sb2‐based thermoelectric generators for low‐grade heat recovery.

High Thermoelectric Performance of Bi-Doped Mg 2 Si 0.4 Sn 0.6 and Mg 2 Si 0.6 Sn 0.4 based on Recyclable Si Kerf Derived from PV Manufacturing

Enhanced thermoelectric performance of Sb-doped Mg2Si0.4Sn0.6 via doping, alloying and nanoprecipitation

Simple Synthesis and Thermoelectric Properties of Mg2 + xSi0.5Sn0.5Sb0.075 Materials with Heterogeneous Microstructure

Flux Synthesis and Thermoelectric Properties of Eco-Friendly Sb Doped Mg2Si0.5Sn0.5 Solid Solutions for Energy Harvesting

High-Performance Low-Cost n-Type Se-Doped Mg3Sb2-Based Zintl Compounds for Thermoelectric Application

High Figures Of Merit And Natural Nanostructures In Mg2si0.4sn0.6 Based Thermoelectric Materials

Energy-Efficient Synthesis and Superior Thermoelectric Performance of Sb-doped Mg2Si0.3Sn0.7 Solid Solutions by Rapid Thermal Explosion

Improved performance in Mg3Sb2/Sb hybrid films for thermoelectric generation

All‐Mg3Sb2‐Based Module for Thermoelectric Power Generation

Enhanced Thermoelectric Performance of p‐Type Mg3Sb2 for Reliable and Low‐Cost all‐Mg3Sb2‐Based Thermoelectric Low‐Grade Heat Recovery

n-type thermoelectric material Mg2Sn0.75Ge0.25 for high power generation

Thermoelectric Performance of Li Doped, P-Type Mg2(Ge,Sn) and Comparison with Mg2(Si,Sn)

High thermoelectric performance and anisotropy studies of n-type Mg3Bi2-based single crystal

Enhanced thermoelectric properties of Mg2Si0.3Sn0.7 via Bi-doping under high pressure

Si-Based Materials for Thermoelectric Applications

Realizing an Excellent Conversion Efficiency of 14.5% in the Mg3Sb2/GeTe-based Thermoelectric Module for Waste Heat Recovery

Scalable Synthesis of N-Type Mg3Sb2-xBix for Thermoelectric Applications

Effect of Sb Doping on the Thermoelectric Properties of Mg<sub>2</sub>Si<sub>0.7</sub>Sn<sub>0.3</sub> Solid Solutions

Preparation and Thermoelectric Properties of Mg2Si1−xSnx

Effect of Sb Doping on the Thermoelectric Properties of Mg 2 Si 0.7 Sn 0.3 Solid Solutions

Thermoelectric properties of n‐type Mg<sub>2</sub>Si<sub>0.6–<i>y</i></sub>Sb<i><sub>y</sub></i>Sn<sub>0.4</sub>compounds