Double quantum dots as a high sensitive submillimeter-wave detector

O. Astafiev,S. Komiyama,T. Kutsuwa

DOI: https://doi.org/10.1063/1.1396628

2001-04-06

Abstract:A single electron transistor (SET) consisting of parallel double quantum dots fabricated in a GaAs/Al$_{x}$Ga$_{1-x}$As heterostructure crystal is demonstrated to serve as an extremely high sensitive detector of submillimeter waves (SMMW). One of the double dots is ionized by SMMW via Kohn-mode plasma excitation, which affects the SET conductance through the other quantum dot yielding the photoresponse. Noise equivalent power of the detector for wavelengths about 0.6 mm is estimated to reach the order of $10^{-17}$ W/$\sqrt{Hz}$ at 70 mK.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop an extremely sensitive sub - millimeter - wave (SMMW) detector. Specifically, the authors aim to use a single - electron transistor (SET) composed of parallel double quantum dots (DQD) to achieve this goal. This detector can detect single photons in the far - infrared range without an applied magnetic field and has extremely high sensitivity.

### Main problems and solutions

1. **Improve the sensitivity of sub - millimeter - wave detectors**:
- **Problem**: Traditional sub - millimeter - wave detectors have limitations in sensitivity and application range, especially without using a strong magnetic field.
- **Solution**: Design and fabricate a SET based on the GaAs/AlGaAs heterostructure, which contains two coupled quantum dots (D1 and D2). One of the quantum dots (D2) can be ionized by sub - millimeter - wave through Kohn - mode plasma excitation, thus affecting the conductivity of the other quantum dot (D1) and generating a photoelectric response.

2. **Achieve single - photon detection (SPD)**:
- **Problem**: Achieve single - photon detection without a magnetic field and extend the detectable wavelength range.
- **Solution**: Utilize the ionization of electrons in D2 after absorbing sub - millimeter - wave energy, which leads to a decrease in the number of electrons in D2 (\(\Delta N_2=- 1\)), further changes the electrochemical potential of D1, and finally causes the displacement of the SET conductance peak, forming a detectable signal change.

3. **Reduce the noise - equivalent power (NEP)**:
- **Problem**: Traditional detectors have a relatively high noise - equivalent power, which limits their application in low - power signal detection.
- **Solution**: By optimizing the device structure and measurement conditions, the noise - equivalent power (NEP) of the detector reaches the order of \(10^{-17}\text{W}/\sqrt{\text{Hz}}\), far lower than the performance of traditional detectors.

### Key mechanisms

- **Kohn - mode plasma excitation**: When D2 is irradiated by sub - millimeter - wave, through Kohn - mode plasma excitation, electrons obtain additional energy \(E^*\) and escape from D2 to D1 or the adjacent electron reservoir, resulting in a decrease in the number of electrons in D2.
- **Conductance peak displacement**: Due to the ionization of D2, the electrochemical potential \(\mu_1\) of D1 changes, causing the SET conductance peak to shift in the negative direction and generating a detectable conductance change.
- **Saturation effect**: At a higher radiation intensity, the photon absorption rate exceeds the reciprocal of the ionization - state lifetime \(\tau_l^{-1}\), resulting in saturation of the photoelectric response.

Through these mechanisms, the authors successfully demonstrated that the SET based on double quantum dots can be used as an extremely sensitive sub - millimeter - wave detector, whose performance is close to the single - photon detection level and does not require an applied magnetic field.