Abstract:Engineering structures are frequently subjected to the variable amplitude loads, which have a significant impact on the fatigue crack growth. In order to understand the relationship between the overload effect and the plas-ticity induced crack closure, we simulated fatigue crack propagation using elastic-plastic finite element method. The techniques of the simulation and the determination of crack opening/closing stresses are introduced. Crack growth induced residual stress distribution and the crack closure behavior are firstly obtained for the baseline loading which is the constant K ( keeping the maximum stress intensity factor as constant and the stress ratio R as 0 during crack growth) cyclic loading. The values of the crack opening/closing stress levels relative to the maximum applied stress keep constant during the crack extension. Then similar results are obtained for different overload cases inserted into baseline cycles, such as a single tensile overload cycle, a single compressive overload cycle, or a single tensile o-verload followed by a compressive overload. The results demonstrate that the compressive residual stress induced by the tensile overload in front of crack tip and later in the wake of the crack causes the increase of crack closure level and the retardation of crack growth. The crack closure effect is weakened instantaneously after the tensile overload and enhanced rapidly along with the crack growth until a level much higher than that of the baseline cycles. The effect of a single compression overload itself on crack closure should be overlooked, but the beneficial effect of a tensile overload can be attenuated by a compressive overload immediately after it by reducing the crack opening/closing levels.

Simulation of near-tip crack behaviour and its correlation to fatigue crack growth with a modified strip-yield model

Fatigue Crack-Closure Analytical Model For Considering Thickness And Hardening Effects

Characterizing Fatigue Crack Closure by Numerical Analysis

A Study of the Numerical Simulation Technique for Fatigue Crack Closure

A Plastic Fracture Mechanics Model for Characterization of Multiaxial Low-Cycle Fatigue

THE CHARACTERIZATION OF PLASTICITY INDUCED FATIGUE CRACK CLOSURE BASED ON NUMERICAL ANALYSIS

Fatigue Crack Closure and Residual Stress Effect of Overload

Crack Tip Field in a Linear Elastic–plastic Strain-Hardening Material

An X-FEM Approach for Simulation of 3-D Multiple Fatigue Cracks and Application to Double Surface Crack Problems

FATIGUE CRACK CLOSURE ANALYSIS UNDER TRIAXIAL STRESS CONSTRAINT

A New Cohesive Crack Tip Symplectic Analytical Singular Element Involving Plastic Zone Length for Fatigue Crack Growth Prediction under Variable Amplitude Cyclic Loading

Prediction of Short Fatigue Crack Propagation Behaviour by Characterization of Both Plasticity and Roughness Induced Crack Closures

An Analytical Model for Fatigue Crack Propagation Prediction with Overload Effect

Modeling of Fatigue Crack Propagation

Near-tip Strain Evolution and Crack Closure of Growing Fatigue Crack under a Single Tensile Overload

An engineering model of fatigue crack growth under variable amplitude loading

A New Approach to Predicting Fatigue Crack Propagation

An improved small-time-scale crack growth rate model considering overloading and load-sustaining effects for deep-sea pressure hulls

Numerical Simulation and Experimental Studies on Elastic-Plastic Fatigue Crack Growth

Prediction of Low Cycle Fatigue Crack Growth under Mixed-mode Loading Conditions Using Cohesive Zone Models

The extended McEvily model for fatigue crack growth analysis of metal structures