Abstract:This study conducted Detached-Eddy Simulations (DES) of actively controlled flow over a 0.35 m chord NACA0015 airfoil at an incidence angle of 11° and a chord Reynolds number of 1 million. The uncontrolled, natural flow were simulated by using DES-type methods, with a comparison of different underlying RANS models and subgrid-scale stress models in LES mode. Results from these computations were compared with experimental observations, enabling their reliable assessment through the detailed investigation of the Reynolds stresses as well as the separation and reattachment. It was found that among all five DES-type methods, only the Spalart–Allmaras-based Improved Delayed DES (IDDES-SA) captured the separation point as measured in the experiments. The classical vortex-shedding and the shear-layer flapping modes for airfoil flows with shallow separation were also extracted from the IDDES-SA results by using Dynamic Mode Decomposition. With better understanding of unsteady flow features, effective control practices were illustrated. The pulsed blowing actuation was adopted according to the experimental settings. The flow-field around jet orifices was resolved, instead of the use of actuation boundary conditions. It was found that for all actuation frequencies investigated in this article, the saturation of lift-to-drag ratio was yielded already at intermediate momentum coefficients, two-fifths of the actuation amplitude used in the experiment; the optimal actuation frequency was 0.6 among all cases, consistent with the dominant frequency of the baseline flow. The suppression of separation bubble led to a maximum lift-to-drag ratio enhancement of 194%, as well as a sharp decrease of all Reynolds stress components. To further reduce the strong unsteadiness introduced by excitation, a phase shift among jet orifices was applied and evaluated. The pulsed blowing with the jet orifices in an anti-phased manner was found to be very effective to damp the fluctuations of the lift around its mean value, though it led to a small decrease in mean lift.

Bluff body drag manipulation using pulsed jets and Coanda effect

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Drag Reduction Via Turbulent Boundary Layer Flow Control

Aerodynamic drag reduction of a simplified squareback vehicle using steady blowing

Biomimetic bluff body drag reduction by self-adaptive porous flaps

Drag reduction using a self-adaptive flexible coating

Heavy Class Helicopter Fuselage Model Drag Reduction by Active Flow Control Systems

Equilibrium of fluid fluxes in the wake of a three-dimensional flat-back bluff body

A zero-net-mass-flux wake stabilization method for blunt bodies via global linear instability

Numerical Investigation of Microbubble Drag Reduction on an Axisymmetric Body Based on Eulerian Multiphase Model

Active Flow Control for Bluff Body Drag Reduction Using Reinforcement Learning with Partial Measurements

Active Control of a Turbulent Boundary Layer Based on Local Surface Perturbation

Drag Reduction of Wake Flow by Shear-Driven Rotation.

Energy efficient actuated drag reduced compressible turbulent flat plate flow

Wake stabilization behind a cylinder by secondary flow over the leeward surface

Active control for a low-drag Ahmed vehicle model based on steady blowing

Design exploration on the drag reduction and thermal protection over a blunted waverider with multiple opposing jets

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation

D-shaped body wake control through flexible filaments

Modal Analysis and Flow Control on a Reduced Scale SUV