Abstract:<span class="a-plus-plus abstract-section id-a-sec1"> <h3 class="a-plus-plus">Abstract</h3> <p class="a-plus-plus">This study is an experimental investigation of the effectiveness and mechanism of a concept for bluff-body control characterized by combined windward suction and leeward blowing (WSLB). Wind tunnel tests are performed at a subcritical Reynolds number (<em class="a-plus-plus">Re</em>) of 3.33 × 10<sup class="a-plus-plus">4</sup>. Open-loop WSLB is used to control the flow around a cylindrical test model. Distributed suction and blowing nozzles are symmetrically arranged at the front and rear stagnation points. Steady suction and blowing are implemented simultaneously on both surfaces of the cylinder. WSLB control is characterized by the dimensionless momentum of the suction/blowing relative to the incoming airflow. Instantaneous pressure distributions on the midspan of the cylinder surface for the baseline and controlled cases are measured to quantify the modifications of WSLB control to the aerodynamic coefficients of the cylinder. In addition to surface pressure measurements, a particle image velocimetry (PIV) system is used to describe the wake flow structures of the baseline and controlled cylinders. Experimental results demonstrate that WSLB control decreases sectional drag at the midspan and reduces the fluctuating amplitudes of dynamic wind loads acting on the cylinder. The Strouhal number to characterize the vortex shedding frequencies of the controlled cylinders is also found to deviate from that of the natural cylinder. PIV measurement results show that the active blowing positioned at the leeward stagnation point forms a pair of vortices into the cylinder wake that modify the original vortex shedding process. As the blowing vortices convect into the wake, they stretch the unsteady shear flows from the upper and lower sides of the cylinder, increase the vortex-formation length and push the alternative vortex shedding further downstream. It is also shown that a steady and symmetric perturbation imposed on the periodic cylinder flow can reduce the von Karman vortices and modify the mode of wake vortex shedding significantly.</p> </span> <span class="a-plus-plus abstract-section id-a-sec2 outputmedium-all"> <h3 class="a-plus-plus">Graphical abstract</h3> <p class="a-plus-plus">With active control of windward suction and leeward blowing (WSLB), blowing positioned at the leeward stagnation point forms a pair of vortices in the cylindrical wake that modifies the typical vortex shedding process. As the blowing vortices convect downstream, they contribute to detaching the unsteady shear layers from the cylinder. It is shown that a steady and symmetric perturbation imposed on the periodic cylinder flow can lead to a symmetric mode of wake vortex shedding. <span class="a-plus-plus figure category-standard float-no id-figa"> <span class="a-plus-plus media-object"> <img alt="" src="https://static-content.springer.com/image/MediaObjects/348_2018_2676_Figa_HTML.png" class="a-plus-plus"/> </span> </span> </p> </span>

Wake stabilization behind a cylinder by secondary flow over the leeward surface

Wake Vortex Evolution of Square Cylinder with A Slot Synthetic Jet Positioned at the Rear Surface

Active control of circular cylinder flow with windward suction and leeward blowing

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

A zero-net-mass-flux wake stabilization method for blunt bodies via global linear instability

Structured porous surface for drag reduction and wake attenuation of cylinder flow

Experimental study on the wake control of a square cylinder mounted with dual rigid/flexible splitter plates in the subcritical regime

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Numerical Study of Porous Treatments on Controlling Flow around a Circular Cylinder

Wake suppression of a cylinder immersed in turbulence using rotating rods

Square cylinder flow controlled by a synthetic jet at one leading edge

Dynamics of the forced wake of a square cylinder with embedded flapping jets

Wake control of a square cylinder: Impinging the vortex cores with dual flexible splitter plates

Transition control of cylinder wake via Lorentz force

Primary instability, sensitivity and active control of flow past two tandem circular cylinders

Attenuation of vortex street by suction through the structured porous surface

Dynamic kirigami structures for wake flow control behind a circular cylinder

Turbulent wake suppression of circular cylinder flow by two small counter-rotating rods

Simulations of passive oscillation of a flexible plate in the wake of a cylinder by immersed boundary method

Sweeping jet control of flow around a circular cylinder

Numerical study on passive-jet flow control for chamfered square cylinder