Abstract:Active control of a turbulent boundary layer has been experimentally investigated with a view to reducing the skin-friction drag and gaining some insight into the mechanism that leads to drag reduction. A spanwise-aligned array of piezo-ceramic actuators was employed to generate a transverse travelling wave along the wall surface, with a specified phase shift between adjacent actuators. Local skin-friction drag exhibits a strong dependence on control parameters, including the wavelength, amplitude and frequency of the oscillation. A maximum drag reduction of 50% has been achieved at 17 wall units downstream of the actuators. The near-wall flow structure under control, measured using smoke-wire flow visualization, hot-wire and particle image velocimetry techniques, is compared with that without control. The data have been carefully analysed using techniques such as streak detection, power spectra and conditional averaging based on the variable-interval time-average detection. All the results point to a pronounced change in the organization of the perturbed boundary layer. It is proposed that the actuation-induced wave generates a layer of highly regularized streamwise vortices, which acts as a barrier between the large-scale coherent structures and the wall, thus interfering with the turbulence production cycle and contributing partially to the drag reduction. Associated with the generation of regularized vortices is a significant increase, in the near-wall region, of the mean energy dissipation rate, as inferred from a substantial decrease in the Taylor microscale. This increase also contributes to the drag reduction. The scaling of the drag reduction is also examined empirically, providing valuable insight into the active control of drag reduction.

Drag reduction using a self-adaptive flexible coating

Drag Reduction Via Turbulent Boundary Layer Flow Control

Biomimetic bluff body drag reduction by self-adaptive porous flaps

Bluff body drag manipulation using pulsed jets and Coanda effect

Drag Reduction of Compressible Wall Turbulence with Active Dimples

An innovative study on low surface energy micro-nano coatings with multilevel structures for laminar flow design

Dynamics of Two-Dimensional Flow Around a Circular Cylinder with Flexible Filaments Attached

Investigation of the drag reduction performance of bionic flexible coating

Drag reduction by flapping a pair of flexible filaments behind a cylinder

Eel skin inspired flexible polymeric coating for drag reduction

Experimental research on drag reduction by polymer additives in a turbulent pipe flow

Drag reduction and antifouling of a spontaneous fast moving air film

Structured porous surface for drag reduction and wake attenuation of cylinder flow

Sustainable drag reduction in Taylor-Couette flow using riblet superhydrophobic surfaces

Drag Reduction of Wake Flow by Shear-Driven Rotation.

Active Control of a Turbulent Boundary Layer Based on Local Surface Perturbation

Sustainable Drag Reduction in Turbulent Taylor-Couette Flows by Depositing Sprayable Superhydrophobic Surfaces

Superhydrophobic surfaces to reduce form drag in turbulent separated flows

Turbulent Drag Reduction in Plane Couette Flow Wit H Polymer Additives: a Direct Numerical Simulation Study

Experiment about drag reduction of bionic non-smooth surface in low speed wind tunnel

Wettability Effects of Curved Superhydrophobic Surfaces On Drag Reduction in Taylor-Couette Flows of Water and Oil