Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Active control for a low-drag Ahmed vehicle model based on steady blowing

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

A bio-inspired device for drag reduction on a three-dimensional model vehicle

Aerodynamic force reduction of rectangular cylinder using deep reinforcement learning-controlled multiple jets

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Drag Reduction of Blowing-Based Active Control in a Turbulent Boundary Layer

Heavy Class Helicopter Fuselage Model Drag Reduction by Active Flow Control Systems

Multi Parameters Control Mechanism on Drag and Heat Reduction of Opposing Jet

Deep reinforcement learning-based active flow control of an elliptical cylinder: transitioning from an elliptical cylinder to a circular cylinder and a flat plate

Active Control of Flow over Rotating Cylinder by Multiple Jets using Deep Reinforcement Learning

Active Control of a Turbulent Boundary Layer Based on Local Surface Perturbation

Design of Variable Weight SDRE Control Algorithm for Civil Aeroengine Transition State

Active flow control for drag reduction through multi-agent reinforcement learning on a turbulent cylinder at $Re_D=3900$

Effect of Synthetic Jets Actuator Parameters on Deep Reinforcement Learning-Based Flow Control Performance in a Square Cylinder

Aerodynamic drag reduction of a simplified squareback vehicle using steady blowing

Bluff body drag manipulation using pulsed jets and Coanda effect

Active control of circular cylinder flow by affiliated rotating cylinders

Aerodynamic optimization of mixed platoon Ahmed body vehicles based on response surface method

Numerical Investigations of Outer-Layer Turbulent Boundary Layer Control for Drag Reduction Through Micro Fluidic-Jet Actuators

Machine-learning flow control with few sensor feedback and measurement noise

Modal Analysis and Flow Control on a Reduced Scale SUV