Abstract:SummaryThis paper investigates a new implementation of a passive fractional‐order capacitor (FOC) based on a single‐component fractional‐order inductor (FOI). The significance of this approach lies in providing the fractional‐order passive circuit to synthesize an FOC, which avoids the approximation that only depends on the integer‐order transfer function and reflects truly the infinite‐dimensional nature of fractional‐order impedance characteristic. For this purpose, the realizable conditions of this passive FOC are obtained and the main ideas of the proposed method are described by examples. The sensitivity of the impedance magnitude and phase angle on required components parameters is also analyzed in order to facilitate the design of the FOC emulator. Furthermore, the bandwidth is extended by modular structures connected in series, and the proposed approach shows an improvement over some previous methods in terms of accuracy. Also, based on the fractional calculus Grünwald–Letnikov definition, a single‐component FOI circuit element is packaged to build simulation circuit in Matlab/Simulink, and the effectiveness of the proposed method are validated by simulated and experimental results. In the application of an FOC, the results from in the series–parallel fractional‐order RLCβ bandreject filter circuit indicate that the fractional‐order counterpart can reduce the ripple and improve the suppression level at a certain frequency, and the peak amplitude and the overshoot decrease initially with decreasing order. Moreover, under the fixed inductance, capacitance, and resistance, the rise time varies almost inversely with order, whereas the setting time is on the decrease as the order is decreasing.

Implementation of a Fractional-Inductor (α<0.5) and its performance study in a high-frequency L α R integrator circuit

Asic Design of an Integrable Simulated Inductor with Huge Inductance

Design Method and Implementation of the Fractional‐order Inductor and Its Application in Series‐resonance Circuit

Compact Fractional-Order Model of On-Chip Inductors with BCB on High Resistivity Silicon

Optimization of Injection Locked Frequency Divider with Tunable Active Inductor

Optimized System Design for Fully Integrated Fractional-N Pll

The design and fabrication of LTCC chip inductors for high frequency applications based on barium ferrites

Passive Realization of the Fractional‐order Capacitor Based on Fractional‐order Inductor and Its Application

Modeling and Performance Improvement of Fractional-Order Band-Pass Filter Using Fractional Elements

Equivalent Circuit Analysis of an RF Integrated Inductor with Ferrite Thin-Film

A RF Integrated Inductor with CoZrO Ferrite Thin Film

Implementation and Characterization of a Tunable Quality Factor Micromachined Inductor

Fully Integrated Ferrite-Based Inductors for Rf Ics

Fractional-Order Modeling and Steady-State Analysis of Single-Phase Quasi-Z-Source Pulse Width Modulation Rectifier

On-Chip Integrated Inductors with Ni-Zn-Cu-Fe and Y-Bi-Fe Ferrite Thin-films for RF IC

On-Chip Integrated Inductors with Ferrite Thin-Films for RF IC

Realization of a fractional-order RLC circuit via constant phase element

A Sub-0.75 Degrees(Rms)-Phase-Error Differentially-Tuned Fractional-N Synthesizer With On-Chip Ldo Regulator And Analog-Enhanced Afc Technique

A 5-Bit Phase-Interpolator-Based Fractional-N Frequency Divider For Digital Phase-Locked Loops

Design and Simulation of Si-Based MEMS Inductor

Using Frequency-Dependent Integer Order Models to Simulate Fractional Order Model for Battery Management