Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

Optimized System Design for Fully Integrated Fractional-N Pll

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Low-Phase-Noise UHF-Band Fractional-N Frequency Synthesizer

A 0.8 V Low Power Low Phase-Noise Pll

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A low-noise, 0.05–17.8-GHz fractional-N phase-locked loop with two parallel synchronized dual-core voltage-controlled oscillators

Low-noise Fractional-N PLL Design with Mixed-Mode Triple-Input LC VCO in 65nm CMOS

A 65nm Cmos 3.6ghz Fractional-N Pll With 5(Th)-Order Delta Sigma Modulation And Weighted Fir Filtering

A Compact, Low-Power, and Low-Jitter Fractional-N Phase-Locked Loop with a Single-Ended Ring Voltage-Controlled Oscillator in a 12 Nm CMOS FinFET

A Low-Power RF CMOS Charge Pump PLL

A Bias-Current-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

A 56-GHz Fractional-N PLL With 110-fs Jitter

A DTC-Free Fractional-N BBPLL with FIR-Embedded Injection-Locked-Oscillator-Based Phase-Domain Lowpass Filter

A Low-Power Calibration-Free Fractional-N Digital Pll with High Linear Phase Interpolator

A Low-Spur Current-Biasing-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

A Low In-Band Phase Noise Fractional-N ADPLL Based on Switched-Capacitor-DPI

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC

A Sub-ps Integrated-Jitter 10 GHz ADPLL with Fractional Capacitor