Abstract:In hydrofracture stress measurements, the magnitude of the maximum horizontal stress, SH, is commonly estimated from the borehole pressure required to reopen an induced axial crack. Examination of the processes which govern the borehole pressure history recorded during the reopening cycle of such tests indicates two sources of error in the estimates of SH derived using the conventional method proposed by Bredehoeft et al. [Bredehoeft JD, Wolff RG, Keys WS and Shutter E, 1976, Colorado. Geol. Soc. Amer. Bull., 87, 250–8]. The first arises from the failure to include a term arising from pressure penetration into the crack prior to reopening in the force balance acting across the mouth of the induced axial cracks. The problem can be remedied by using a modified ‘reopening equation’ which includes pressure penetration of the crack. The second source of error is more problematic and concerns the correct identification of the true reopening pressure from the borehole pressure records. Analysis of the process of reopening aided by numerical simulations shows that the true reopening pressure is generally less than the apparent (i.e. that detected) reopening pressure. The discrepancy between true and apparent reopening pressures increases with larger hydraulic compliance of the test equipment. The compliance in question refers to that of the fluid volume between the flow meter and the crack mouth(s). Simulation of a pair of 1 m high axial cracks with 2 μm residual hydraulic aperture in a 100 mm borehole, indicates that the system compliance must be reduced to 5×10−7 m3/MPa to enable the true reopening pressure to be estimated to better than 10%, at flow rate is less than 10−4 m3/s. This is several orders of magnitude less than applies to conventional hydrofracture systems, but is attainable for tests in small holes at shallow depth by making relatively minor system modifications. Tests at greater depth, however, would seem to require downhole measurement of flow at the packers. We validate our assertions with a field test in which reopening pressure was determined mechanically and hydraulically.

Two methods for hydraulic fracturing stress measurements needless the ambiguous reopening pressure

Hydraulic fracture reopening pressure and the estimation of maximum horizontal stress

Analysis of crack reopening behavior for hydrofrac stress measurement

Reopening Behavior of Transverse Cracks in Hydraulic Fracturing Tectonic Stress Measurements.

Theoretical Analysis of Crack Reopening Behavior in Hydraulic Fracturing Tectonic Stress Measurements

An Innovative Method to Analyze the Hydraulic Fracture Reopening Pressure of Hot Dry Rock

Two New Methods for Defining Shut-In Pressure in Hydraulic Fracturing Tests

The critical pressures for crack closure, crack reopening and crack instability in hydraulic fracturing

A new borehole method to measure in situ maximum horizontal stress

Discussion on Application of Hydraulic Fracturing Method to Geostress Measurement

Research and application of small-diameter hydraulic fracturing in situ stress measurement system

Comparison of the classical and fracture mechanics approaches to determine in situ stress/hydrofracturing method

Stress state analysis in the vicinity of the hydraulic fracturing tool located near the bottom of the well

Data interpretation method in HF stress measurement for the total stress tensor determination in rock mass

Stress tensor determination by modified hydraulic tests on pre-existing fractures: Method and stress constraints

Investigating the closure stress and crack initiation stress in fractured rocks using the student t distribution and Monte Carlo simulation method

Experimental and numerical study of measuring in-situ stress in horizontal borehole by hydraulic fracturing method

Discussion of the Paper SPE-187038-MS: Fracture Closure Stress: Reexamining Field and Laboratory Experiments of Fracture Closure Using Modern Interpretation Methodologies

Method and Application of Stress Inversion based on Strike, Dip, and Rake Data from Microseismic Focal Mechanisms and Fracture Network

Study on a Calculation Model for 3D In-Situ Rock Stress Tensor

A test method for the in-situ stress of salt rock