Abstract:The combination of electric heating and thermal energy storage (TES) with phase change material (PCM) can achieve load shifting for air conditioning energy saving in building sectors. Their non-flammability, relatively good mechanical properties, and low cost make inorganic PCMs attractive in construction engineering. However, PCMs often show poor thermal conductivity, low heat transfer efficiency, leakage risk, etc., in applications. Moreover, the practical thermal performance of PCM-TES sometimes fails to meet demand variations during charge and discharge cycles. Therefore, in this study, a novel integrated electric PCM wall panel module is proposed with quick dynamic thermal response in space heating suitable for both retrofitting of existing buildings and new construction. Sodium-urea PCM composites are chosen as PCM wall components for energy storage. Based on the enthalpy-porosity method, a mathematical heat transfer model is established, and numerical simulation studies on the charge-discharge characteristics of the module are conducted using ANSYS software. Preliminary results show that the melting temperature decreases from 50 °C to approximately 30 °C with a 30% urea mixing ratio, approaching the desired indoor thermal comfort zone for space heating. With declining PCM layer thickness, the melting time drops, and released heat capacity rises during the charge process. For a 20 mm thick PCM layer, 150 W/m2 can maintain the average surface temperature within a comfort range for 12.1 h, about half the time of a 24 h charge-discharge cycling periodicity. Furthermore, placing the heating film in the unit center is preferable for improving overall heat efficiency and shortening the time to reach the thermal comfort temperature range. This work can provide guidance for practical thermal design optimization of building envelopes integrated with PCM for thermal insulation and energy storage.

Experimental and Numerical Performance Analysis of an Active Cooling Wall Module Equipped with Micro-encapsulated Phase Change Material

Numerical Study on the Thermal Performance of Phase Change Materials Wall by Radiative Cooling

Experimental study on the performance of a novel RC-PCM-wall

Parametric Analysis of the Phase Change Material Wall Combining with Micro-Channel Heat Pipe and Sky Radiative Cooling Technology

A Novel Molecular PCM Wall with Inorganic Composite: Dynamic Thermal Analysis and Optimization in Charge-Discharge Cycles

Parametric analysis of influencing factors in Phase Change Material Wallboard (PCMW)

CFD analysis on heat transfer in a building wall using Phase Change Materials (PCM)

Experimental analysis of a radiant floor system incorporating phase change materials: Thermal performance and energy efficiency

A parametric study on the thermal response of a building wall with a phase change material (PCM) layer for passive space cooling

Experimental Assessment on the Use of Phase Change Materials (Pcms)-Bricks in the Exterior Wall of a Full-Scale Room

Parametric Analysis on Performances of the Pipe-Encapsulated PCM (penpcm) Wall System Coupled with Gravity Heat-Pipe and Nocturnal Radiant Cooler

Numerical Study on the Effect of Incorporating Phase Change Materials in a Wall

Optimization of the Phase-Change Wallboard Test Method: Experimental and Numerical Investigation

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Thermoeconomic analysis of a wall incorporating phase change material in a rural residence located in northeast China

Performance Evaluation of a PCM-embedded Wall Integrated with a Nocturnal Sky Radiator

Experimental Study on the Thermal Performance of Air-Pcm Unit

Performance analysis of a novel phase-change wall of wood structure coupled with sky-radiation cooling

Enhancing Thermal Performance of Buildings Through Macro-Encapsulated PCM Integration in Wall and Roof

Numerical Thermal Characterization and Performance Metrics of Building Envelopes Containing Phase Change Materials for Energy-Efficient Buildings

Experimental Thermal Performance of Wallboard with Hybrid Microencapsulated Phase Change Materials for Building Application