Abstract:Abstract According to the report published by the International Energy Agency (IEA), active space cooling and air conditioning systems consume approximately 16% of the building sector’s final electricity consumption and contribute 3.94% of global greenhouse gas emissions. In this regard, the use of low-cost but effective passive solutions, such as organic phase change materials (PCM) on the building envelope, can provide high thermal mass and thus can lower the temperature fluctuation inside the building. In the current study, the potential of PCM-enhanced building envelopes to enhance thermal comfort has been studied. The study has been performed using the conduction finite difference (ConFD) algorithm in EnergyPlus software. A comparative study has been done for a traditional reinforced cement concrete (RCC) reference test room of size (5m x 6m x 3m) and another room of the same size with PCM-enhanced walls for the hot and humid climate zone of Guwahati (latitude 26.1, longitude 91.7), in India. A PCM thickness of 20 mm is used at the external surface of the wall between the red clay burnt brick (120 mm in thickness) and the cement plaster (25mm thick). The PCM used for the study is a biocomposite PCM, named WH-PCM, with a melting point of 31.5°C and thermal conductivity of 0.27 W/mK. The simulation results reveal that the R-value of the external wall of the room with PCM walls has been increased by 84.90% compared to the reference room with the incorporation of WH-PCM, resulting in a mean zone temperature difference of 0.3°C throughout the year. Also, the indoor thermal discomfort hours have been annually reduced by 15.82% with the use of WH-PCM when compared with the reference room. A similar temperature difference trend, which is 1.93°C, is also observed in the single PCM brick experimental result under identical testing conditions as a regular brick of the same size.

A parametric study on the thermal response of a building wall with a phase change material (PCM) layer for passive space cooling

Increasing the thermal inertia of building walls when using phase change materials

Parametric Analysis of the Phase Change Material Wall Combining with Micro-Channel Heat Pipe and Sky Radiative Cooling Technology

Parametric Analysis of Using PCM Walls for Heating Loads Reduction

Influence of wall thermal performance on the contribution efficiency of the Phase-Change Material (PCM) layer

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Heat transfer reduction in buildings by embedding phase change material in multi-layer walls: Effects of repositioning, thermophysical properties and thickness of PCM

Thermal Performance Analysis of Lightweight Phase Change Envelopes

Numerical analysis for the optimal location of a thin PCM layer in frame walls

On the Placement of a Phase Change Material Thermal Shield Within the Cavity of Buildings Walls for Heat Transfer Rate Reduction

Design of Phase Change Material Wall Based on the Heat Transfer Characteristics in Summer

Numerical Study on the Effect of Incorporating Phase Change Materials in a Wall

Dynamic integration of phase change material in walls for enhancing building thermal performance—A novel self-adaptive method for moving PCM layer

Experimental and Numerical Performance Analysis of an Active Cooling Wall Module Equipped with Micro-encapsulated Phase Change Material

Numerical Study on the Thermal Performance of Phase Change Materials Wall by Radiative Cooling

Impacts of PCM Location and Thickness on Dynamic Thermal Characteristics of External Walls for Residential Buildings

Thermoeconomic analysis of a wall incorporating phase change material in a rural residence located in northeast China

CFD analysis on heat transfer in a building wall using Phase Change Materials (PCM)

Experimental and Numerical Study of the Thermal Performance of a New Type of Phase Change Material Room

Study on optimization of thermal property parameters of phase change wallboard and its application simulation in the building

Experimental study on the performance of a novel RC-PCM-wall