Abstract:Laser powder bed fusion (LPBF) uses a focused, high power laser to repeatedly scan geometric patterns on thin layers of metal powder, which build up to a final, solid three-dimensional (3D) part. This process is somewhat limited in that the parts tend to have poorer surface finish (compared to machining or grinding) and distortion due to residual stress, as well as multiple other deficiencies. Typical laser scan strategies are relatively simple and use constant laser power levels. This elicits local variations in the melt pool size, shape, or temperature, particularly near sharp geometric features or overhang structures due to the relatively higher thermal conductivity of solid metal compared to metal powder. In this paper, we present a new laser power control algorithm, which scales the laser power to a value called the geometric conductance factor (GCF). The GCF is calculated based on the amount of solid vs. powder material near the melt pool. The algorithm for calculating GCF is presented along with some basic examples for clarification. Then, we detail the hardware and software implementation on the National Institute of Standards and Technology (NIST) additive manufacturing metrology testbed (AMMT), which includes co-axial melt pool monitoring using a high-speed camera. Six parts were fabricated out of nickel superalloy 625 (IN625) with the same nominal laser power, but with varying GCF algorithm parameters. We demonstrate the effect of tailored laser power on reducing the variability of melt pool intensity measured throughout the 3D build. Finally, we contrast the difference between the 'optimized' part vs. the standard build parameters, including the deflection of the final part top surface near the overhang and the variation of surface finish on the down-facing surfaces. Ultimately, the improvements to the in-situ process monitoring and part qualities demonstrate the utility and future potential tuning and optimizing more complex laser scan strategies.

Influence of environmental constraints and carrier gas velocity on powder concentration and temperature distribution during laser inside additive manufacturing process

Numerical simulation of powder effect on solidification in directed energy deposition additive manufacturing

Investigating the Effects of Powder Feeding Rate on Microstructure Transformation in Linear Laser Beam Additive Manufactured Thick-Walled Structures

Influence of Process Parameters on the Interlaminar Shear Strength of CF/PEEK Composites In-Situ Consolidated by Laser-Assisted Automated Fiber Placement

Influence of shielding gas flow consistency on parts quality consistency during large-scale laser powder bed fusion

Thermal behavior and fluid dynamics within molten pool during laser inside additive manufacturing of 316L stainless steel coating on inner surface of steel tube

Study on the influence of laser power variation on the temperature Field of laser additive manufacturing Airport fuel supply pipe network

Additive manufacturing inert gas flow path strategies for multi-laser powder bed fusion systems and their impact on lattice structure mechanical responses

Modeling of Temperature Field Evolution During Multilayered Direct Laser Metal Deposition

Microstructural control in metal laser powder bed fusion additive manufacturing using laser beam shaping strategy

Effect of Interlayer Cooling Time, Constraint and Tool Path Strategy on Deformation of Large Components Made by Laser Metal Deposition with Wire

Part geometry and conduction-based laser power control for powder bed fusion additive manufacturing

Influence of particle morphology and size distribution on the powder flowability and laser powder bed fusion manufacturability of Ti-6Al-4V alloy

The effect of process parameters on the stability and efficiency in the laser powder bed fusion of Ti-6Al-4 V based on the interval powder layer thickness

Dynamics of pore formation during laser powder bed fusion additive manufacturing

Effect of Processing Parameters on Thermal Phenomena in Direct Laser Metallic Powder Deposition

Numerical and experimental investigation of the geometry dependent layer-wise evolution of temperature during laser powder bed fusion of Ti–6Al–4V

Effect of processing parameters on surface roughness, porosity and cracking of as-built IN738LC parts fabricated by laser powder bed fusion

Experimental and computational study on thermal and fluid behaviours of powder layer during selective laser melting additive manufacturing

Coupled Computational Fluid Dynamics-Discrete Element Method Model for Investigation of Powder Effects in Nonconventional Laser Powder Bed Fusion Process

Resolving thermal gradients and solidification velocities during laser melting of a refractory alloy