Abstract:The intake duct is an important component of waterjet propulsion system and its hydraulic performance is directly connected with the capability of the waterjet pump and even the propulsion performance of the system. In order to optimize the flush-type intake duct, the present paper proposes a multi-objective optimization system including Design of Experiments (DOE), Computational Fluid Dynamics (CFD), three-dimensional parametric design, approximate model, the modified Non-dominated Sorting Genetic Algorithm-II (NSGA-II) and a Technique for Ordering Preferences by Similarity to Ideal Solution (TOPSIS). The nonuniformity and perpendicularity of outflow, and hydraulic efficiency for the intake duct are treated as the optimization objectives with four geometrical parameters as the design variables. Local sensitivity analyses indicate that the optimization objectives are significantly affected by the inclination angle and slightly affected by the lip vertical distance of the intake duct. During IVR = 0.3-0.8, the outflow quality and hydraulic efficiency of the optimised intake duct are greatly improved. The nonuniformity after optimization decreases by 27.8% and perpendicularity increases by 3.07% at the design condition of IVR = 0.7 and V-s = 19.49 m/s. Based on the flow at the outlet plane of intake duct, the pressure distribution after optimization is very uniform and the tangential velocity is small without obvious secondary flow. During the application to a mixed-flow waterjet propulsion system at various navigation speeds, the nonuniformity of the optimized intake duct decreases by 20.4% and perpendicularity increases by 4.11% on average, demonstrating that the optimized intake duct performs a better outflow quality. It is also noted that the non-uniform flow from the intake duct mainly affects pressure distribution on the suction surface of impeller blade and causes different shaft power.

Parametric optimization of vortex generator configuration for flow control in an intake duct for waterjet propulsion

Study On Vortex Generators For Control Of Attached Cavitation

Multi-objective Optimization of the Flush-Type Intake Duct for a Waterjet Propulsion System

Control Effect of Micro Vortex Generators on Leading Edge of Attached Cavitation

Distortion Control in Intakes Subject to Strong Crosswinds Using Steady Vortex Generator Jets

Large Eddy Simulation Investigation of Micro-Vortex Generator Control Effect on Early Stage Sheet Cavitation

Research on the Effect of Vortex Generators on Controlling Flow Separation of Hydrofoil

Control Effect of Micro Vortex Generators on Attached Cavitation Instability

Optimal Design of Inlet Passage for Waterjet Propulsion System Based on Flow and Geometric Parameters

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Large Eddy Simulation of Micro Vortex Generator-Controlled Cavitation Across Multiple Stages

Numerical study on improving the hydrodynamic performance of three-dimensional unsteady hydrofoil through vortex generators

Experimental and numerical investigations into flow features in an intake duct for the waterjet propulsion under mooring conditions

Effect Mechanisms of Leading-Edge Tubercle on Blade Cavitation Control in a Waterjet Pump

Investigations into the unsteady internal flow characteristics for a waterjet propulsion system at different cruising speeds

Efficient Design Method for Applying Vortex Generators in Turbomachinery

Hydrodynamic characteristics of a waterjet propulsion pump with front straight guide vane

Investigation of air-core vortex at hydraulic intakes

Numerical Simulation and Experimental Study on an Innovative Vortex Eliminator Using a Modified SST Turbulence Model for Gas-Liquid Two-Phase Flow

Hydrodynamic flow separation control through vortex generators

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods