Abstract:This study offers an efficient method for commercial-size proton exchange membrane fuel cell (PEMFC) stack performance evaluation to improve designing of fuel cell and maximize power density in PEMFC stack. The flow distribution in the manifold of the stack is critical to the energy conversion of the assembled unit cells in series due to the typical short-board effect. Most existing works studying on the flow distribution focus on small fuel cell stack and does not establish a clear relationship to performance, which are not able to thoroughly guide commercial-size PEMFC stack design and development. In the present study, an effective method combining computational fluid dynamics (CFD) model and empirical model is proposed to evaluate the performance of commercial-size stack considering air flow distribution in the manifold. Firstly, the air flow distribution in the manifold is predicted by a CFD model. A performance evaluation empirical model is developed by a series of experiments to evaluate the effects of flow maldistribution on the performance of PEMFC stack. Then, the predicted flow distribution and performance are respectively validated by a novel experimental setup. Finally, the effects of stack configuration, cell number, and current density on flow distribution and performance of PEMFC stacks are discussed. The results show that U-type configuration promotes more uniform voltage among unit cells than Z-type. The voltage unevenness of unit cells caused by flow maldistribution climbs dramatically as the cell number and current density increase. The methodology developed is beneficial to the energy management and the efficiency improvement of commercial-size PEMFC stack.

A CFD‐based manifold design methodology for large‐scale PEM fuel cell stacks

Analysis and improvement of flow distribution in manifold for proton exchange membrane fuel cell stacks

Manifold geometry optimization and flow distribution analysis in commercial-scale proton exchange membrane fuel cell stacks

Entrance Effects on the Flow Distribution in Manifold of Commercial-Size Proton Exchange Membrane Fuel Cell Stacks

Optimization of Entrance Geometry and Analysis of Fluid Distribution in Manifold for High-Power Proton Exchange Membrane Fuel Cell Stacks

Improvement of air distribution consistency in large-scale proton exchange membrane fuel cell stack manifold

Cfd Analysis of A Novel Modular Manifold with Multi-Stage Channels for Uniform Air Distribution in A Fuel Cell Stack

Analytical and numerical investigation of flow distribution in PEMFC stacks

Manifold Design in a PEM Fuel Cell Stack to Improve Flow Distribution Uniformity

Numerical Simulation of Flow Distribution for External Manifold Design in Solid Oxide Fuel Cell Stack

A Re-Optimized Design of Mesh-Type Transition Zone for Large-Scale PEM Fuel Cells Considering Two-Phase Flow Distribution

Numerical Modeling of Manifold Design and Flow Uniformity Analysis of an External Manifold Solid Oxide Fuel Cell Stack

Structural design and optimization for a 20-cell solid oxide fuel cell stack based on flow uniformity and pressure drop

Eccentricity design for the coolant distribution optimization of a practical commercial-size proton exchange membrane fuel cell stack using a novel proper orthogonal decomposition based analysis model

Study on the Effects of Manifold Structure on the Gas Flow Distribution Uniformity of Anode of PEMFC Stack with 140-Cell

A Method to Study the Intake Consistency of the Dual-Stack Polymer Electrolyte Membrane Fuel Cell System under Dynamic Operating Conditions

Flow uniformity analysis and optimization of a 60-cell external manifold solid oxide cell stack with bottom-accesses

Flow Distribution Analysis In The Sofc Stack Using Cfd Technique

A Novel Design of Distribution Zone in Scaled-Up PEM Fuel Cells Based on Active Control of Transverse Flow

A Model Reduction Framework of Flow Maldistribution and Mitigation Strategy for Parallel Flow Field Based Polymer Exchange Membrane Fuel Cell

Optimization of Gas Distribution in DMFC Stacks Based on Experiments and CFD Simulations