Abstract:Most of the existing studies on acid corrosion of concrete have focused on the mechanical behavior of concrete structures under monotonic load or without load. To investigate the mechanical properties of in-service concrete components under cyclic load in an acid corrosion environment, six groups of concrete prism specimens with different acid corrosion degrees (corrosion duration) were designed and prepared by the accelerated corrosion test method. The monotonic and cyclic axial compression load tests on these specimens were conducted to investigate the effects of corrosion degree on the mechanical properties of concrete specimens. The experimental results indicated that hydrochloric acid corrosion has obvious effects on the failure characteristics and mechanical properties of concrete. The surface of corroded concrete was easier to crack and spall under load, and the concrete spalling area enlarged as the acid corrosion duration increased. The compressive capacity of concrete specimens reduced rapidly with the increase in corrosion duration. The stress–strain envelope curves for concrete with different corrosion duration under cyclic load were essentially similar to that of concrete under monotonic load. The degradation rate of the descending section for the stress–strain curves of corroded concrete under cyclic load was much larger than that under the monotonic load due to the accumulation of internal damage in concrete. The peak strain and ultimate strain of corroded concrete increased significantly with the increase in corrosion duration and enhanced by 55.7% and 77.9%, respectively, compared with the uncorroded concrete, whereas the peak stress and elastic modulus rapidly decreased and reduced by 53.3% and 74.1%, respectively. Moreover, based on the strength degradation depth, the concept of effective bearing cross-sectional area ratio was proposed to characterize the corrosion degree of concrete, and the correction coefficient of descending section for the effective bearing cross-sectional area ratio was introduced to establish the constitutive model of corroded concrete under cyclic load, and the results calculated by this model matched well with the experimental values. The research in this paper can provide the experimental and theoretical basis for seismic life cycle and fatigue redesign of concrete structures in acid corrosion environments or coastal areas.

Durability of concrete subjected to acidic exposure attack under flexural loading

Concrete Deterioration Mechanisms under Combined Sulfate Attack and Flexural Loading

Sulphate attack resistance of high-performance concrete under compressive loading

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Experimental investigation on the fracture properties of concrete under different exposure conditions

Experimental study on underground structure concrete under static bending loads and sulfate attack

Flexural Behaviour of Reinforced Concrete Beams under Freeze–thaw Cycles and Sustained Load

Chloride penetration in concrete exposed to cyclic drying-wetting and carbonation

Study on the Behavior and Durability of Reinforced Concrete in Boric Acid Environment

Behavior of Reinforced Concrete Subjected to Boric Acid Corrosion of Nuclear Power Plant

Experimental Investigation on the Influence of Strength Grade on the Surface Fractal Dimension of Concrete under Sulfuric Acid Attack

Experimental study of the deterioration mechanism of concrete under sulfate attack in wet-dry cycles

Decay of fracture parameters of concrete under sulfate environments

Experimental Investigation on Microstructure and Surface Morphology Deterioration of Limestone Exposed on Acidic Environment

Study on Mechanical Properties and Constitutive Relationship of Concrete Corroded by Hydrochloric Acid under Cyclic Load

Chloride transport resistance of alkali-activated concrete exposed to combined chloride, sulfate and carbonation environment

Chloride Penetration into Concrete Damaged by Uniaxial Tensile Fatigue Loading

Chloride Transport Behavior in Bending-Shear Section of Reinforced Concrete Beam under Combined Effect of Load and Environment

Research on the performance evolution of concrete under the coupling effects of sulfate attack and carbonation

Mechanical Properties and Damage Evolution of Concrete Materials Considering Sulfate Attack

Deterioration Process of Concrete Exposed to Internal Sulfate Attack