Abstract:PurposeTo achieve a higher level of satisfaction in patients having undergone Total Knee Arthroplasty (TKA), a more personalized approach has been discussed recently. It can be assumed that a more profound knowledge of bony morphology and ligamentous situation would be beneficial. While CT/MRI can give 3D information on bone morphology, the understanding of the ligamentous situation in different flexion angles is still incomplete. In this study, the dynamic gap widths of a large number of varus knees were assessed in various flexion angles, to find out whether all varus knees behave similar or have more individual soft tissue patterns. Additionally, it was investigated whether the amount of varus deformity or other patient factors have an effect on joint gap widths.MethodsA series of 1000 consecutive TKA patients, including their CAS data and patient records were analyzed. Joint gap widths in multiple flexion angles (0°, 30°, 60°, 90°) were measured in mm and differences between the joint gaps were compared. A "standard" varus knee was defined as follows: (1) Lateral extension gap greater than medial, (2) lateral flexion gap greater than medial, and (3) flexion gap greater than extension gap. The percentage of fulfillment was tested for each and all criteria. To measure the influence of varus deformity on gap width difference, three subgroups were formed based on the deformity. Data were analyzed at 0°, 30°, 60° and 90° flexion. The effect of patient factors (gender, BMI, age) on gap sizes was tested by performing subgroup analyses.ResultsOnly 444 of 680 (65%) patients met all three varus knee criteria. The lateral extension gap (4.1 mm) was significantly larger than the medial extension gap (0.6 mm) in 657 (97%) patients and the gap difference highly correlated with the amount of varus deformity (r2 = 0.62). In all flexion positions, however, no correlation between gap differences and varus deformity existed. Women had significantly larger extension and flexion gaps. Age and BMI showed no significant effect on gap widths.ConclusionVarus knees show a large inter-individual variability regarding gap widths and gap differences. The amount of varus deformity correlates highly with the medio-lateral gap difference in extension, but not in any flexion angle. As varus knees are not all alike, a uniform surgical technique will not treat all varus knees adequately and the individual gap sizes need to be analyzed and addressed accordingly with an individualized balancing technique. Which final balancing goal should be achieved needs to be analyzed in future studies.Level of evidenceLevel III.

Propensity of the tight mid-flexion and loose flexion gap despite the adjustment of extension and flexion gaps in Oxford unicompartmental knee arthroplasty: retrospective study

Intraoperative loose flexion gap may restrict postoperative knee flexion after J-curve design posterior-stabilized total knee arthroplasty

Accuracy of total knee arthroplasty using the modified gap technique based on the bone gap: an evaluation of the bone gap with a distal femoral trial component

Increased Posterior Condylar Offset Decreases the Extension Gap in Cases With Flexion Contracture in Modified Gap Technique Total Knee Arthroplasty

Good accuracy of the Phase III Oxford Mobile Bearing Unicompartmental Knee Instrumentation

Intraoperative Sensor Technology Quantifies Inter-Prosthesis Pressure for Predicting Lower Limb Alignment after Oxford Unicompartmental Knee Arthroplasty.

Association of intraoperative medial joint gap laxity in the flexion position with subjective knee instability after fixed-bearing posterior-stabilised total knee arthroplasty

[Research Progress of Larger Flexion Gap Than Extension Gap in Total Knee Arthroplasty].

Posterior capsular release around the intercondylar notch increases extension gap without affecting flexion gap in posterior-stabilized total knee arthroplasty

The Disproportionate Increase of the Intraoperative Flexion and Extension Gap Space after Posterior Cruciate Ligament Resection in Total Knee Arthroplasty

Correlation Between Femorotibial Pressure and Joint Gap in Osteoarthritis Patients with Varus Deformity: an Intraoperative Measurement Using Sensor Device in Primary Posterior-Stabilized Total Knee Arthroplasty

A single type of varus knee does not exist: morphotyping and gap analysis in varus OA

Joint gap measurement in total knee arthroplasty using a tensor device with the same articulating surface as the prosthesis

Effect of tibia‐first, restricted functional alignment technique on gap width changes, and component positioning in robotic arm‐assisted total knee arthroplasty

Improved total knee arthroplasty pain outcome when joint gap targets are achieved throughout flexion

Maintaining the Physiological Lateral Flexion Gap in the Kinematically Aligned TKA Does Not Compromise Clinical Outcomes at One-Year Follow-Up

Association Between Overhang of the Posterior Femoral Condyle and Restricted Postoperative Knee Flexion Related to Patient-Reported Stiffness in Medial-Pivot Total Knee Arthroplasty

A new gap balancing technique with functional alignment in total knee arthroplasty using the MAKO robotic arm system: a preliminary study

Altered dynamic joint space in the lateral condyle compartment following medial unicompartmental knee arthroplasty

Excessive flexed position of the femoral component causes abnormal kinematics and joint contact/ ligament forces in total knee arthroplasty

Difference in the Extension Gap Between Osteoarthritis and Osteonecrosis in Medial Fixed-Bearing Unicompartmental Knee Arthroplasty with the Spacer Block Technique