Abstract:Background: Total knee replacement (TKR) is considered one of the most common elective orthopaedic procedures. The main focus of TKR is to offer patient's symptomatic relief from persistent knee pain. To achieve this it is crucial to restore joint biomechanics by performing proper bone cuts. Some surgeons favor the measured resection technique, others prefer gap balancing technique. The researchers of the presented study performed TKR using these two techniques. The aim of this study was to compare the postoperative change in joint line and posterior condylar offset after TKR with use of anatomic knee design implants between gap balancing and measured resection techniques. Methods: Two hundred twenty-five X-rays of patients who underwent TKR performed by a single surgeon between 2020 and 2021 were analyzed. The first group of patients (101) was operated with the use of gap balancing technique and the second group (124) was operated with the use of measured resection technique. Patients included in the study were > 50 years of age, had confirmed primary knee osteoarthritis, underwent primary TKR with a PS (posterior stabilized) knee implants without patella resurfacing and had at least 15 degree flexion contracture. T-student test and U Mann-Whitney test were used in statistical analysis of results, according to the normality of distribution examined with the Shapiro-Wilk test. Post-hoc analysis was performed using the Dwass-Steel-Crichtlow-Fligner test (DSCF). Results: The postoperative analysis showed a significantly elevated joint line level in the gap balancing group (-2.6 ± 4.1 vs -0.7 ± 4.8, p < 0.0005). In the gap balancing group significantly more patients had joint lines elevated > 2 mm comparing to measured resection technique. The difference between pre- and postoperative PCO (posterior condylar offset) and PCOR (posterior condylar offset ratio) results had no significant differences (100.8 ± 11.8 vs 101 ± 12.5, p > 0.05) between the groups. Conclusions: The results of the study suggest that when it comes to restoring joint line level measured resection technique seems to be superior in comparison to the gap balancing technique. What is more, results indicate measured resection is equal in terms of restoring posterior condylar offset to the gap balancing technique. Trial registration: NCT04164147, date of registration: November 14, 2019.

Joint gap measurement in total knee arthroplasty using a tensor device with the same articulating surface as the prosthesis

Measurement of joint gap load in patella everted and reset position during total knee arthroplasty

Accuracy of total knee arthroplasty using the modified gap technique based on the bone gap: an evaluation of the bone gap with a distal femoral trial component

Correlation Between Femorotibial Pressure and Joint Gap in Osteoarthritis Patients with Varus Deformity: an Intraoperative Measurement Using Sensor Device in Primary Posterior-Stabilized Total Knee Arthroplasty

Intraoperative loose flexion gap may restrict postoperative knee flexion after J-curve design posterior-stabilized total knee arthroplasty

Patient-specific instrumentation combined with a new tool for gap balancing is useful in total knee replacement: a 3-year follow-up of a retrospective study

Spacer rotation technique allows precise evaluation of gap balance in total knee arthroplasty

Differences in joint line level and posterior condylar offset during total knee replacement with use of gap-balancing and measured resection techniques-matched cohort study

Proven accuracy for a new dynamic gap measurement in navigated TKA

A new gap balancing technique with functional alignment in total knee arthroplasty using the MAKO robotic arm system: a preliminary study

Measurement of femoral posterior condylar offset and posterior tibial slope in normal knees based on 3D reconstruction

An electronic force sensor accurately detects increased but not decreased soft tissue tension in total knee arthroplasty

The Disproportionate Increase of the Intraoperative Flexion and Extension Gap Space after Posterior Cruciate Ligament Resection in Total Knee Arthroplasty

Effect of tibia‐first, restricted functional alignment technique on gap width changes, and component positioning in robotic arm‐assisted total knee arthroplasty

Can tibia-first total knee arthroplasty using computer-assisted system improve anterior and posterior knee stability?

A New Methodology for the Accurate Measurement of Tibiofemoral Kinematics in Human Cadaveric Knees: An Evaluation of the Anterior–Posterior Laxity Pre- and Post-Cruciate Ligament Resection

Propensity of the tight mid-flexion and loose flexion gap despite the adjustment of extension and flexion gaps in Oxford unicompartmental knee arthroplasty: retrospective study

The tibial growth plate as a predictor of the original tibial plateau joint line as a reference for kinematically aligned total knee arthroplasty

Association of intraoperative medial joint gap laxity in the flexion position with subjective knee instability after fixed-bearing posterior-stabilised total knee arthroplasty

Tourniquet does not affect intraoperative kinematics during total knee arthroplasty: Results of a prospective study using a robotic assistance system

High three‐dimensional accuracy of component placement and lower limb alignment using a robotic arm‐assisted system and gap‐balancing instrument in total knee arthroplasty