Abstract:Objective: The purpose of this study was to determine whether the gap-balancing technique with patient-specific instrumentation (PSI) and a new balancing device in total knee arthroplasty (TKA) can improve knee function to a greater extent than can the measured resection technique. Materials and methods: Data from 150 patients who underwent TKA from August 2014 to June 2016 were studied retrospectively. The gap-balancing technique assisted by PSI and the new balancing device was used in 80 patients (82 knees), and the measured resection technique was used in 70 patients (70 knees). The surgical, imaging, and knee function data were compared. Results: The gap-balancing technique assisted by PSI and the new balancing device was found to be feasible in all operated knees and reliable. In total, 150 patients (152 knees) of ages ranging from 52 to 78 years (mean 67 years) underwent TKA during the study period. The follow-up period ranged from 35 to 52 months (mean 45 months). Only one patient, who was included in the gap-balancing group, underwent a revision surgery at 2 years postoperatively due to infection. There were no differences in the incidence of anterior knee pain between the two groups. The mean flexion angle, KSS scores, and VAS scores did not significantly differ between the measured resection group and gap-balancing group at 12 weeks or 36 weeks postoperatively. The average joint line displacement was 1.3 ± 1.1 mm (range 0-3) proximally in the GB (gap-balancing) group and 1.2 ± 1.4 mm in the MR (measured-resection) group. No outliers >5 mm in either group were recorded. The mean leg axis deviation from the neutral mechanical axis was 1.8°±1.5° varus (range 0°-3°varus) versus the neutral mechanical axis in the GB group and 1.4°±1.2°(range 0°-3°)in the MR group. No outliers with >3° deviation in either group were recorded. Conclusions: The gap-balancing technique performed with the new balancing device and PSI can yield accurate femoral component alignment as well as outcomes similar to those of measured resection at 3 years. The new balancing device can be taken into consideration by surgeons who prefer performing the gap-balancing technique with PSI.

Correlation Between Femorotibial Pressure and Joint Gap in Osteoarthritis Patients with Varus Deformity: an Intraoperative Measurement Using Sensor Device in Primary Posterior-Stabilized Total Knee Arthroplasty

Measurement of femoral posterior condylar offset and posterior tibial slope in normal knees based on 3D reconstruction

Intraoperative loose flexion gap may restrict postoperative knee flexion after J-curve design posterior-stabilized total knee arthroplasty

An electronic force sensor accurately detects increased but not decreased soft tissue tension in total knee arthroplasty

Intraoperative Sensor Technology Quantifies Inter-Prosthesis Pressure for Predicting Lower Limb Alignment after Oxford Unicompartmental Knee Arthroplasty.

Can Intraoperative Intra-Articular Loads Predict Postoperative Knee Joint Laxity Following Total Knee Arthroplasty? A Cadaver Study with Smart Tibial Trays

Accuracy of total knee arthroplasty using the modified gap technique based on the bone gap: an evaluation of the bone gap with a distal femoral trial component

Joint gap measurement in total knee arthroplasty using a tensor device with the same articulating surface as the prosthesis

Association of intraoperative medial joint gap laxity in the flexion position with subjective knee instability after fixed-bearing posterior-stabilised total knee arthroplasty

The Use of Electronic Sensor Device to Augment Ligament Balancing Leads to a Lower Rate of Arthrofibrosis After Total Knee Arthroplasty

A New System for Soft-Tissue Balance Measurement in Total Knee Replacement

A new gap balancing technique with functional alignment in total knee arthroplasty using the MAKO robotic arm system: a preliminary study

Total Knee Arthroplasty in Ranawat II Valgus Deformity with Enlarged Femoral Valgus Cut Angle: A New Technique to Achieve Balanced Gap.

A Method for Dynamically Measuring the Soft Tissue Balance in the Total Knee Replacement

Influence of Preoperative Deformity on Flexion Gap Asymmetry in Measured Resection Technique: A Theoretical Study in Navigated Gap Balancing Total Knee Arthroplasties, Done for Varus Knee Osteoarthritis

Effect of Posterior Cruciate Ligament on Knee Pressure and Gap Measured by an Electronic Sensor During Total Knee Arthroplasty

Accuracy of Soft Tissue Balancing in Total Knee Arthroplasty Using Surgeon-Defined Assessment Versus a Gap-Balancer or Electronic Sensor

In Vitro Kinematic Measurements of the Patellar Tendon in Two Different Types of Posterior-Stabilized Total Knee Arthroplasties

Patient-specific instrumentation combined with a new tool for gap balancing is useful in total knee replacement: a 3-year follow-up of a retrospective study

Improved total knee arthroplasty pain outcome when joint gap targets are achieved throughout flexion

The Disproportionate Increase of the Intraoperative Flexion and Extension Gap Space after Posterior Cruciate Ligament Resection in Total Knee Arthroplasty