Abstract:Ceramic fibers are ideal candidates for high-temperature resistance material due to their excellent oxidation resistance, ablation resistance, and mechanical properties. In this study, precursor solutions of the continuous SiOC, and SiMOC (M = Al/Zr) ceramic fibers were prepared by a modified sol-gel method. The precursor fibers were fabricated by dry spinning, followed by pyrolysis at 800 °C, 1000 °C, and 1200 °C to yield continuous SiOC, SiAlOC, and SiZrOC ceramic fibers. The microstructure, surface morphologies, compositions, mechanical properties, and thermal stability of the continuous SiOC and SiMOC ceramic fibers were thoroughly examined by relevant characterization. The results showed that the continuous SiMOC fibers exhibited smooth surfaces and dense structures with effective formation of Si-O-M bonds. The measured tensile strength of fabricated continuous SiAlOC and SiZrOC ceramic fibers revealed optimum values of 139.8 MPa and 162.4 MPa, respectively, much higher than the continuous SiOC ceramic fibers (124 MPa), showing excellent mechanical properties. The continuous SiMOC fibers demonstrated remarkable resistance to high-temperature ablation and oxidation, maintaining structural integrity after exposure to a butane flame for 60 s and heat treatment in air at 1300 °C for 1 h. Additionally, the continuous SiZrOC fibers displayed excellent infrared reflectance of 10.28%, suggesting their potential as superior thermal insulation material in high-temperature applications.

Continuous aluminum oxide-mullite-hafnium oxide composite ceramic fibers with high strength and thermal stability by melt-spinning from polymer precursor

Effect of hafnium oxide on continuous aluminum oxide-mullite-hafnium oxide composite ceramic fibers

Zirconia-alumina multiphase ceramic fibers with exceptional thermal stability by melt-spinning from solid ceramic precursor

Studies on the Crystallization Behavior of Al2O3-HfO2 Ceramic Fibers Prepared by Melt-spinning of Polymer Precursors

Effect of calcination temperatures on HfO2 fibers via electrospinning

High-temperature resistance and thermal insulation performance of continuous SiMOC ceramic fibers fabricated by the modified sol-gel method combined with dry spinning

Preparation of silicon-nitride ceramic fibers with hafnium compounds loaded on the surface and the high temperature properties

Preparation of Continuous Aluminum Oxide Fibers with Silicon Oxide and Zirconium Oxide Additives

Effect of high temperature annealing on microstructure and mechanical properties of Morlion735 alumina fiber

Fabrication and Thermal Stability of Continuous Carbon Fiber Reinforced Alumina Matrix Composites via Sol–Gel Process

Preparation and Mechanical Property of Alumina Fibers Reinforced Thin Architectural Ceramic Plate

Fabrication and properties of three-directional orthogonal aluminosilicate fiber fabric-reinforced mullite composite

Strength degradation of alumina fiber: Irreversible phase transition after high-temperature treatment

Synthesis and Characterization of Electrospun Mullite Nanofibers

Microstructure evolution and mechanical behavior of a mullite fiber heat‐treated from 1100 to 1300°C

Fabrication and Evaluation on Thermal Stability of Hafnium Diboride Matrix Composite at Severe Oxidation Condition

Preparation and Properties of MgAl<sub>2</sub>O<sub>4</sub>-CaAl<sub>12</sub>O<sub>19</sub> High Temperature Composite

Fibrous Monolithic Ceramic with a Single Alumina Phase: Fracture and High‐temperature Tribological Behaviors

Synthesis of an (Al3BC + Al2O3)/Al composite with high stiffness and attractive high-temperature tensile properties

Development Of The Thermo-Conductive Electrically Insulating Epoxy Composites Using Electrospun Alumina Microfibers

Preparation and Characterization of Alumina-coated Hollow Quartz Fiber Reinforced Al2O3-SiO2 Aerogel Composite