Abstract:The development of sensitive fiber-optic accelerometers is a subject of continuing interest. To acquire high resolution, Michelson phase interferometric techniques are widely adopted. Among the variety structures, the compliant cylinder approach is particularly attractive due to its high sensitivity that is defined as the induced phase shift per applied acceleration. While the two arms of Michelson interferometer should be at the same optical path, it is inconvenient to adjust the two arms' length to equal, also the polarization instability and phase random drift will cause a signal decline. To overcome these limitations, a novel optical fiber accelerometer based on differential interferometric techniques is proposed and investigated. The interferometer is a Sagnac-like white light interferometer, which means the bandwidth of laser spectrum can be as wide as tens nanometers. This interferometer was firstly reported by Levin in 1990s. Lights are divided to two paths before entering the coupler. To induce time difference, one passes through a delay arm and another goes a direct arm. After modulated by the sensing component, they reflect to opposite arm. The sensing part is formed by a seismic mass that is held to only one compliant cylinder, where the single-mode optical fiber is wrapped tightly. When sticking to vibrations, the cylinder compresses or stretches as a spring. The corresponding changes in cylinder circumference lead to strain in the sensing fibers, which is detected as an optical phase shift by the interferometer. The lights from two arms reach the vibration source at different time, sensing a different accelerate speed; produce a different optic path difference. Integrating the dissimilarity of the accelerated speed by time can obtain the total acceleration graph. A shaker's vibration has been tested by the proposed accelerometer referring to a standard piezoelectric accelerometer. A 99.8% linearity of the optical phase shift to the ground acceleration is achieved. The acceleration sensitivity is 300 rad/g. It proves to have a simple structure, good practice, reliable measurement and stable performance.

Ultra-high-resolution phase demodulation based miniature fiber-optic accelerometer at low and medium frequencies

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Optical Design and Analysis of a High Resolution MOEMS Accelerometer Based on Diffraction Grating

A High-Resolution Fiber Optic Accelerometer Based on Intracavity Phase-Generated Carrier (PGC) Modulation

The Modulation and Demodulation Module of a High Resolution MOEMS Accelerometer

Research On Accelerometer Based On Multi-Mode Interference

Theoretical Model and Design of Highly Sensitive Reflective Fiber Optic Fabry-Pérot Cavity Accelerometer Independent of Fiber Stiffness

Highly sensitive multicore fiber accelerometer for low frequency vibration sensing

An FBG-FPI Accelerometer Based on Femtosecond Laser-Written Ultrashort Fiber Bragg Gratings

A Novel Differential Optical Fiber Accelerometer

The Design and Simulation of a Coarse-to-Fine Optical MEMS Accelerometer

Fiber Optic Accelerometer Based on Fiber-Mirror Interference Cavity

High Sensitivity Optical MEMS Accelerometer Based on a Metal Fabry–Pérot Microcavities Wavelength Modulation System

Fiber Fabry-Perot accelerometer with extended dynamic range and low noise floor

Dual straight-wing FBG accelerometer for low-frequency vibration measurement

Enhanced quasi-distributed accelerometer array based on φ-OTDR and ultra-weak fiber Bragg grating

A microchip optomechanical accelerometer

Sensitivity Enhancement Method for Dual-Polarization Interferometric Fiber-Optic Angular Accelerometer