Abstract:Abstract:A 0.27 mm-thick grain-oriented silicon steel sheet with extra-low carbon was successfully produced by a novel processing route including strip casting, normalizing, two-stage cold rolling with an intermediate annealing, primary annealing, and secondary recrystallization annealing. The evolutions of microstructure and texture along the whole processing route were investigated with a special emphasis on the effects of two-stage cold rolling schedule. It was found that Goss orientation originated in the first cold rolling due to shear banding and relatively strong Goss texture evolved through the whole thickness after intermediate annealing. This is significantly different from the results in conventional process in which the origin of Goss texture is in the hot rolling stage and Goss texture only develops below the sheet surface. Besides, it was found that cold rolling schedule had significant influences on microstructure homogeneity, evolution of λ-fiber texture in primary annealed state and, thus, on secondary recrystallization. In case of appropriate cold rolling schedule, a homogeneous microstructure with Goss texture, relatively strong γ-fiber texture and medium α-fiber texture was observed in the primary annealed strip. Although Goss texture in primary annealed state was much weaker than that in two-stage route in conventional process, a perfect secondary recrystallization microstructure was produced and the magnetic induction B8 was as high as 1.85 T. By contrast, when the cold rolling schedule was inappropriate, the primary annealed strips exhibited inhomogeneous microstructure, together with weak γ-fiber texture, medium α-fiber and λ-fiber texture. Finally, the sheets showed incomplete secondary recrystallization microstructure in which a large number of fine grains still existed.

Experimental investigation and simulation of crystallographic orientations evolution in a cold-rolled ultra-thin grain-oriented silicon steel

Influence of Cold Rolling Reduction on the Deformation Behaviour and Crystallographic Orientation Development

Evolutions of Cube ({001} ) and {115} Orientations in Cold-Rolled Ultra-Thin Non-Oriented Silicon Steel

Crystal Plasticity Analysis of the Orientation-Dependent Grain Rotation and Fragmentation Behaviors in Ferritic Stainless Steel During Cold Rolling

Influence of Cold Rolling Direction on Texture, Inhibitor and Magnetic Properties in Strip-Cast Grain-Oriented 3% Silicon Steel

Investigation of microstructure and texture as related to primary recrystallization of grain-oriented silicon steel

TEXTURE DISTRIBUTION AND DEVELOPMENT THROUGH THE THICKNESS AFTER CROSS SHEAR ROLLING OF GRAIN ORIENTED SILICON STEEL

The Early Stage Formation of Shear Orientations and the Stability of //ND Orientations During Hot Rolling in Electrical Steels

Study on the recrystallization microstructure and texture evolution of a rolled 0.075 mm ultra-thin grain-oriented silicon steel

Evolution of {0kl} 〈1 0 0〉 texture and microstructure in preparation of ultra-thin grain-oriented silicon steel

Effect of cold-rolling deformation and rare earth yttrium on microstructure and texture of oriented silicon steel

Microstructure and texture evolution of ultra-thin high grade non-oriented silicon steel used in new energy vehicle

Microstructural evolution and magnetic properties in strip cast non-oriented silicon steel produced by warm rolling

Effects of Strain Rate on Shear Bands and Texture Evolution in Grain-oriented Silicon Steel

Evolution of the Shear Band in Cold-Rolling of Strip-Cast Fe-1.3% Si Non-Oriented Silicon Steel

The origin of {113} grains and their impact on secondary recrystallization in producing ultra-thin grain-oriented electrical steel

EFFECT OF COLD ROLLING PROCESS ON TEXTURE EVOLUTION OF GRADIENT MICROSTRUCTURE IN Fe-3,0 % Si NON-ORIENTED SILICON STEEL

Development of microstructure and texture in strip casting grain oriented silicon steel

Effects of Two-Stage Cold Rolling Schedule on Microstructure and Texture Evolution of Strip Casting Grain-Oriented Silicon Steel with Extra-Low Carbon

EVOLUTION OF LOCAL ORIENTATIONS WITHIN INDIVIDUAL GRAINS IN ROLLED PURE POLYCRYSTALLINE ALUMINUM

Texture transition of shear bands in initially Goss–oriented grains in Fe–3 wt%Si alloy