Abstract:Ni nanoparticles supported on ZrO2 are a prototypical system for reforming catalysis converting methane to synthesis gas. Herein, we examine this catalyst on a fundamental level using a 2-fold approach employing industrial-grade catalysts as well as surface science based model catalysts. In both cases we examine the atomic (HRTEM/XRD/LEED) and electronic (XPS) structure, as well as the adsorption properties (FTIR/PM-IRAS), with emphasis on in situ/operando studies under atmospheric pressure conditions. For technological Ni-ZrO2 the rather large Ni nanoparticles (about 20 nm diameter) were evenly distributed over the monoclinic zirconia support. In situ FTIR spectroscopy and ex situ XRD revealed that even upon H2 exposure at 673 K no full reduction of the nickel surface was achieved. CO adsorbed reversibly on metallic and oxidic Ni sites but no CO dissociation was observed at room temperature, most likely because the Ni particle edges/steps comprised Ni oxide. CO desorption temperatures were in line with single crystal data, due to the large size of the nanoparticles. During methane dry reforming at 873 K carbon species were deposited on the Ni surface within the first 3 h but the CH4 and CO2 conversion hardly changed even during 24 h. Post reaction TEM and TPO suggest the formation of graphitic and whisker-type carbon that do not significantly block the Ni surface but rather physically block the tube reactor. Reverse water gas shift decreased the H2/CO ratio. Operando studies of methane steam reforming, simultaneously recording FTIR and MS data, detected activated CH4 (CH3 and CH2), activated water (OH), as well as different bidentate (bi)carbonate species, with the latter being involved in the water gas shift side reaction. Surface science Ni-ZrO2 model catalysts were prepared by first growing an ultrathin "trilayer" (O-Zr-O) ZrO2 support on an Pd3Zr alloy substrate, and subsequently depositing Ni, with the process being monitored by XPS and LEED. Apart from the trilayer oxide, there is a small fraction of ZrO2 clusters with more bulk-like properties. When CO was adsorbed on the (fully metallic) Ni particles at pressures up to 100 mbar, both PM-IRAS and XPS indicated CO dissociation around room temperature and blocking of the Ni surface by carbon (note that on the partially oxidized technological Ni particles, CO dissociation was absent). The Ni nanoparticles were stable up to 550 K but annealing to higher temperatures induced Ni migration through the ultrathin ZrO2 support into the Pd3Zr alloy. Both approaches have their benefits and limitations but enable us to address specific questions on a molecular level.

Interface-directed epitaxially growing nickle ensembles as efficient catalysts in dry reforming of methane

Nickel‐Catalyzed Dry Reforming of Methane Via Modulating the Zirconia Shapes

Tuning metal-support interactions in nickel-zeolite catalysts leads to enhanced stability during dry reforming of methane

Recent advances in promoting dry reforming of methane of Nickel-based catalysts

Enhanced Dry Reforming of Methane Catalysis by Ni at Heterointerfaces between Thin MgAlOx and Bulk ZrO2

Design Dual Confinement Ni@S-1@SiO2 2 Catalyst with Enhanced Carbon Resistance for Methane Dry Reforming

Design Dual Confinement Ni@S-1@SiO2 Catalyst with Enhanced Carbon Resistance for Methane Dry Reforming

Dually Confined Ni-based Catalysts by Ion-Exchange Inverse Loading for Dry Reforming of Methane

Surface Spectroscopy on UHV-Grown and Technological Ni-ZrO2 Reforming Catalysts: From UHV to Operando Conditions

Dry reforming of methane for syngas production over noble metals modified M-Ni@S-1 catalysts (M = Pt, Pd, Ru, Au)

Confining Ni and ceria in silica shell as synergistic multifunctional catalyst for methane dry reforming reaction

Highly Efficient and Stable Methane Dry Reforming Enabled by a Single-Site Cationic Ni Catalyst

Overcoming the kinetic and deactivation limitations of Ni catalyst by alloying it with Zn for the dry reforming of methane

Robust Nanosheet-Assembled Al2O3-supported Ni Catalysts for the Dry Reforming of Methane: the Effect of Nickel Content on the Catalytic Performance and Carbon Formation

Dry reforming of methane by stable Ni–Mo nanocatalysts on single-crystalline MgO

Enhanced Thermocatalytic Stability by Coupling Nickel Step Sites with Nitrogen Heteroatoms for Dry Reforming of Methane

Methane Dry Reforming by Ni-Cu Nanoalloys Anchored on Periclase-Phase MgAlO<i><sub>x</sub></i> Nanosheets for Enhanced Syngas Production

Preparation adjacent Ni-Co bimetallic nano catalyst for dry reforming of methane

Confined High Dispersion of Ni Nanoparticles Derived from Nickel Phyllosilicate Structure in Silicalite-2 Shell for Dry Reforming of Methane with Enhanced Performance

Bimetallic Nickel-Cobalt catalysts and their application in dry reforming reaction of methane

Rationally constructing metastable ZrO 2 supported Ni catalysts for highly efficient and stable dry reforming of methane