Discharge Characteristics and Detectability of Metal Particles on the Spacer Surface in Gas-Insulated Switchgears

Xing Li,Weidong Liu,Yuan Xu,Dengwei Ding

DOI: https://doi.org/10.1109/tpwrd.2021.3055533

IF: 4.825

2022-02-01

IEEE Transactions on Power Delivery

Abstract:Metal particles and dirty contaminants on the spacer surface are mainly considered to be the critical factor in sudden flashovers. Understanding the discharge characteristics as well as the detectability of metal particles in the gas-insulated switchgear (GIS) will be helpful in improving its safety and reliability. In this paper, a high-sensitivity measurement system based on cross-reference pulse current (PC) and ultra-high-frequency (UHF) methods was established. The PC and UHF signals generated by partial discharges (PDs) of metal particles of different lengths (Φ = 0.5 mm, L = 2, 5, 8, and 10 mm) at different positions on a real spacer surface were studied. The PD characteristics and detectability of the metal particles on the spacer surface were obtained while the detection limitation was also discussed. It is found that under PD test condition, the apparent charge of the PDs is less than 1 pC for particles shorter than 5 mm, and the conventional PD detection method have limitations in detecting these short particles on the spacer surface. Under operation condition, only the apparent charge of particles longer than 8 mm can exceed 1 pC, which means it is difficult to detect the particles shorter than 8 mm in field. However, the result indicates that even the 5 mm long particle will be harmful to the GIS. Meanwhile, it is also been found that the detection sensitivity also has a great influence on the judgement of PD severity. This study is of great interest for understanding the PD characteristics, discharge levels, and detectability of short metal particles on spacer surface.

engineering, electrical & electronic