Abstract:Quaternary chalcogenide Cu 2 CoSnS 4 (CCTS) thin films were successfully prepared by spray pyrolysis on glass substrates in varying the precursor concentration and the thiourea volume. The effects of the precursor concentration and the thiourea volume on the formation of the CCTS phase were systematically investigated by X-ray diffraction, Raman spectroscopy, Energy-Dispersive X-ray Spectroscopy. The electrical resistivity at room temperature has been measured by the four probes method. It is shown that the crystallization of the stannite CCTS phase depends on both the precursor concentration and thiourea volume. The minimum volume of thiourea required to crystallize the CCTS phase depends on the precursor concentration, i.e. the CCTS crystallization needs higher volume of thiourea at low precursor concentration. For higher precursor concentration, the CCTS is poorly crystallized with the presence of secondary phases such as CuS 2 , CoS 2 , and CuCo 2 S 4 , while the crystallization domain is relatively large. The CCTS well crystallizes only in a narrow range of precursor concentration and thiourea volume. The relatively poor crystallization combined with the presence of secondary phases are harmful for the optical and electrical features of the CCTS film. Besides, optical transmission measurements of the optimized film showed an optical gap of 1.7 eV (~ 730 nm) and an absorption coefficient included between 10 4 and 10 5 cm −1 in the visible solar range. Furthermore, the optimized stannite CCTS films are compact exhibiting a relatively rough and granular surface due to the formation of copper sulfide nodules. The electrical resistivity of the optimized CCTS film is about 0.4 10 –2 Ω cm. These results suggest that the deposited films fit the requirements of absorbing layer in solar cells. The diode composed of Au/Cu 2 CoSnS 4 /SnO 2 films was investigated with current–voltage ( I – V ) measurements performed under dark and bright conditions. The series resistance, saturation current and ideality factor of typical diode is estimated to be 689 Ω, 1.15 10 –5 A and 3, respectively.

Electrodeposition of Cu2FeSnS4 thin films for solar cell applications: mechanism of deposition and influence of Fe2+ concentration

Electrodeposition of Cu2NiSnS4 absorber layer on FTO substrate for solar cell applications

Electrodeposition mechanism of Cu 2 CoSnS 4 thin films onto FTO-coated glass: Effect of some additives

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Synthesis of Cu2CoSnS4 chalcogenide thin films by spray pyrolysis and efficient Au/p-CCTS/n-SnO2 diode for cells solar applications

Chemical bath deposition of SnS:Cu/ZnS for solar hydrogen production and solar cells

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

In-Depth Study of Chemically Electrodeposited Cuprous Oxide (Cu2O) thin Films on ITO Glass

Structural, optical and magnetic properties of Cu 2 NiSnS 4 thin films deposited by facile one-step electrodeposition

Fabrication of Cu2SnS3 Thin Film Solar Cells Via a Sol-Gel Technique in Air

Formation of Cu2SnS3 thin film by the heat treatment of electrodeposited SnS–Cu layers

Low-cost Fabrication of Cu 2 ZnSnS 4 Thin Films for Solar Cell Absorber Layers

Synthesis, Growth and Characterization of Cu2CoSnS4 Thin Films via Thermal Evaporation Method

The Electronic and Optical Properties of FeS2 (pyrite) Thin Films Obtained Via Electrodeposition

Growth of copper indium diselenide ternary thin films (CuInSe2) for solar cells: Optimization of electrodeposition potential and pH parameters

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

In situ solvothermal growth of Cu2ZnSnS4 thin film for counter electrode of dye-sensitized solar cells

Influence of deposition potential and substrate characteristics on the photovoltaic conversion efficiency of p-SnS absorbing layers

Substrate and Cu concentration-dependent physical properties of spray-deposited Cu2ZnSnS4 thin films: a comparative study

Pulsed potential co-electrodeposition of Cu2CoSnS4 absorber layer on fluorinated tin oxide (FTO)-coated glass