Abstract:The insufficient ionic conductivity of oxide-based solid electrolytes and the large interfacial resistance between the cathode material and the solid electrolyte severely limit the performance of room-temperature all-solid-state sodium rechargeable batteries. A NASICON solid electrolyte Na3.4Zr1.9Zn0.1Si2.2P0.8O12, with superior room-temperature conductivity of 5.27 × 10–3 S cm–1, is achieved by simultaneous substitution of Zr4+ by aliovalent Zn2+ and P5+ by Si4+ in Na3Zr2Si2PO12. The bulk conductivity and grain boundary conductivity of Na3.4Zr1.9Zn0.1Si2.2P0.8O12 are nearly 20 times and almost 50 times greater than those of pristine Na3Zr2Si2PO12, respectively. The FeS2||polydopamine-Na3.4Zr1.9Zn0.1Si2.2P0.8O12||Na all-solid-state sodium batteries, with a polydopamine modification thin layer between the solid electrolyte and the cathode, maintain a high reversible capacity of 236.5 mAh g–1 at a 0.1 C rate for 100 cycles and a capacity of 133.1 mAh g–1 at 0.5 C for 300 cycles, demonstrating high performance for all-solid-state sodium batteries.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsenergylett.0c01432?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsenergylett.0c01432</a>.Experimental section; XRD, NPD, SEM, and EIS measurements for different solid electrolyte materials; STEM-EDS and DC polarization measurement for Zn0.1 sample; EDS measurement for Zn0.1 sample before and after contact with sodium; unit cell parameters of different solid electrolyte materials; structural parameters of different solid electrolyte materials; BVEL analysis and the comparison of bottleneck sizes; conductivities, activation energies, and relative densities of different solid electrolyte materials; FTIR measurement for Zn0.1 pellet with and without PDA layer; charge–discharge curves of FeS2||Zn0.1||Na all-solid-state battery; comparison of conductivities and battery performances reported in the literature and in this work; cross-sectional images of the cathode/electrolyte interface before and after cycling (<a class="ext-link" href="/doi/suppl/10.1021/acsenergylett.0c01432/suppl_file/nz0c01432_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Zirconia-free NaSICON solid electrolyte materials for sodium all-solid-state batteries

Pristine NASICON Electrolyte: A High Ionic Conductivity and Enhanced Dendrite Resistance Through Zirconia (ZrO2) Impurity-free Solid-Electrolyte Design

Composite NASICON (Na3Zr2Si2PO12) Solid-State Electrolyte with Enhanced Na+ Ionic Conductivity: Effect of Liquid Phase Sintering

Si3N4-Assisted Densification Sintering of Na3Zr2Si2PO12 Ceramic Electrolyte toward Solid-State Sodium Metal Batteries

Bi2O3-Assisted Sintering of Na3Zr2Si2PO12 Electrolyte for Solid-State Sodium Metal Batteries

Enhanced ionic conductivity of Cu-doped NASICON solid electrolyte for solid-state sodium batteries

NASICON-structured Na3.1Zr1.95Mg0.05Si2PO12 solid electrolyte for solid-state sodium batteries

Aliovalent dual element co-assisted strategy to enhance ionic conductivity and stability of NASICON-type solid electrolyte for all-solid-state sodium batteries

Rare Earth Oxide-Assisted Sintered NASICON Electrolyte Composed of a Phosphate Grain Boundary Phase with Low Electronic Conductivity

Enhancing Na-ion conducting capacity of NASICON ceramic electrolyte Na3.4Zr2Si2.4P0.6O12 by NaF sintering aid

Thin NASICON Electrolyte to Realize High Energy Density Solid‐State Sodium Metal Battery

Improving Na/Na 3 Zr 2 Si 2 PO 12 Interface via SnO x /Sn Film for High‐Performance Solid‐State Sodium Metal Batteries

Simultaneously enhancing ionic conductivity and interfacial stability by Fe 2 O 3 for solid-state sodium metal batteries

Enhanced Room-Temperature Na+ Ionic Conductivity in Na4.92Y0.92Zr0.08Si4O12

Interface Stability between Na3Zr2Si2PO12 Solid Electrolyte and Sodium Metal Anode for Quasi-Solid-State Sodium Battery

Increase ionic conductivity of a Zn2+/F− synergy Na3Zr2Si2PO12 solid electrolyte for sodium metal batteries

Enhanced grain connection and ionic conductivity of Na3.3La0.3Zr1.7Si2PO12 ceramic electrolyte by adding Na2B4O7

Ultrastable All-Solid-State Sodium Rechargeable Batteries

A Monolithic Solid-State Sodium–Sulfur Battery with Al-Doped Na 3.4 Zr 2 (Si 0.8 P 0.2 O 4 ) 3 Electrolyte

Na3Zr2Si2PO12 solid-state electrolyte with glass-like morphology for enhanced dendrite suppression

Oxygen-regulated Spontaneous Solid Electrolyte Interphase Enabling Ultra-Stable Solid-State Na Metal Batteries.