Confining the reactions on active facet enhances the simultaneous removal of NO x and toluene by copper-titanium catalysts

Haoyu Shi,Xue Li,Liping Deng,Mengkui Tian,Wanglai Cen,Yaoji Chen,Xiaolong Liu,Tingyu Zhu

DOI: https://doi.org/10.1016/j.fuel.2024.131157

IF: 7.4

2024-02-11

Fuel

Abstract:Exposure of the low adsorption energy barrier facet facilitates the interaction between the catalyst support and the active species, and morphology modification was considered to be a feasible strategy to regulate the exposure of specific facet. The TiO 2 support with hollow spherical shell structure (h-TiO 2 ) was prepared using hard template method, and CuO was loaded on the inside and outside of h-TiO 2 to obtain catalysts with different loading positions (Cu@h-TiO 2 , Cu/h-TiO 2 ). For the efficient catalyst Cu@h-TiO 2 , NO conversion was above 95 % and N 2 selectivity exceeded 90 % in the range of 250–275 °C. In this catalyst, CuO was loaded on the internal low adsorption energy barrier facet of anatase TiO 2 (2 0 0). In comparison to Cu/h-TiO 2 , and Cu@h-TiO 2 exhibited more acidic site, stronger redox ability and reduced the temperature of toluene oxidation to match the temperature for NH 3 -SCR. Based on DFT studies, the adsorption energies of three adsorbates: toluene, NH 3 , and H 2 O on two types of anatase TiO 2 crystal facets (2 0 0) and (1 0 1) were calculated, respectively. The results revealed that the adsorbates had a lower energy barrier on the (2 0 0) facet, which indicated a higher activation efficiency for the three adsorbates on this facet.

energy & fuels,engineering, chemical