Abstract:Developing ceria-based NH3-SCR catalysts possessing excellent NO conversion, N2 selectivity, and SO2-tolerance at low-temperatures remains a great challenge. Precisely regulating the surface structure of ceria-based NH3-SCR catalysts at the atomic scale is paramount to boosting catalytic performance. Herein, we carried out a combined computational and experimental study to rationally engineer the surface structure of CeTiOx NH3-SCR catalysts and to unravel the reactivity descriptors and structure sensitivity. DFT calculations indicate that the Ti-doped CeO2 solid solution structure not only displays a lower activation barrier for the rate-determining step but also separates the SO2 binding site and the catalytic active site, where the Ti dopant serves as a SO2-trapping site while Ce site neighboring Ti and O vacancy next-neighboring Ti act as the dominant active sites for NH3-SCR. These DFT calculation results successfully guided the design and synthesis of highly effective Ti-doped CeO2 solid solution catalysts, which exhibit superior intrinsic activity and excellent SO2-resistant ability for low-temperature NH3-SCR reaction in comparison with the Ce-Ti catalysts containing an amorphous Ce-O-Ti structure and CeO2-TiO2 interface structure. Both DFT calculations and in situ DRIFTS results validate that the NH3-SCR reaction on Ti-doped CeO2 solid solution dominantly follows the Eley–Rideal mechanism. The combined DFT calculations, H2-TPR, NH3-TPD, and catalyst evaluation results reveal that EH/ENH3 and Evac are the two key reactivity descriptors that determine the overall NH3-SCR reaction on Ce-Ti-based catalysts. A volcano-type relationship between NH3 dissociation activity and EH/ENH3 and a strong linear correlation between N–O bond breaking activity and Evac were established. The superior intrinsic NH3-SCR activity of Ti-doped CeO2 solid solution originates from its moderate EH/ENH3 and Evac values. The role of the Ti dopant in Ti-doped CeO2 solid solution as a SO2-trapping site to protect the catalytic active sites from sulfation was unraveled based on TG, TPDC, and in situ DRIFTS characterizations and DFT calculations. The structure sensitivity of Ce-Ti catalysts in NH3-SCR reaction was analyzed based on the atomic coordination structure, and it was found that the four-coordinated tetrahedron-type Ti configuration in Ti-doped CeO2 solid solution assures its superior catalytic performance.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.1c00311?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.1c00311</a>.Catalyst characterization method, optimized structures of NH3-SCR reaction on Ti-doped CeO2 and CeO2–TiO2 interface (Figures S1–S7), catalyst evaluation under a high GHSV value of 90,000 h–1 (Figure S8), SO2+ H2O resistance test (Figure S9), pyridine-adsorbed FTIR and in situ DRIFTS (Figures S10 and S11), correlation between EH and Evac (Figure S12), NO conversion and N2 selectivity on the TiO2/CeO2 catalyst (Figure S13), XPS spectra (Figure S14), in situ DRIFTS under SO2 conditions (Figure S15), BET surface area and pore structure results (Table S1), and comparison of SO2-tolerance with the literature (Table S2) (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.1c00311/suppl_file/cs1c00311_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Improved surface acidity of CeO2/TiO2 catalyst by Cu doping to enhance the SCR catalytic activity

C,N‐modified TiO2‐supported Mn–Ce–Cox‐based Catalyst for Low‐temperature NH3‐SCR

Promoting the catalytic activity and SO2 resistance of CeO2 by Ti-doping for low-temperature NH3-SCR: Increasing surface activity and constructing Ce3+sites

Promotional Effects on NH3-SCR Performance of CeO2–SnO2 Catalysts Doped by TiO2: A Mechanism Study

Active Site of O2 and Its Improvement Mechanism over Ce-Ti Catalyst for NH3-SCR Reaction

Promotional effect of Ce in NH3-SCO and NH3-SCR reactions over Cu-Ce/SCR catalysts

Effect of Ce Doping of TiO2 Support on NH3-SCR Activity over V2O5–WO3/CeO2–TiO2 Catalyst

Solid-phase impregnation promotes Ce doping in TiO2 for boosted denitration of CeO2/TiO2 catalysts

Unraveling Reactivity Descriptors and Structure Sensitivity in Low-Temperature NH3-SCR Reaction over CeTiOx Catalysts: A Combined Computational and Experimental Study

Influence of CeO2 loading on structure and catalytic activity for NH3-SCR over TiO2-supported CeO2

CuOx and WOx modified CeO2-TiO2 with various morphologies for the selective catalytic reduction of NOx with NH3

Enhancing the K resistance of CeTiOx catalyst in NH3-SCR reaction by CuO modification

Enhanced low-temperature NH<sub>3</sub>-SCR performance of CeTiO<i><sub>x</sub></i> catalyst via surface Mo modification

Unraveling Reactivity Descriptors and Structure Sensitivity in Low-Temperature NH 3 -SCR Reaction over CeTiO x Catalysts: A Combined Computational and Experimental Study

Promotional Effects of Titanium Additive on the Surface Properties, Active Sites and Catalytic Activity of W/CeZrOx Monolithic Catalyst for the Selective Catalytic Reduction of NOx with NH3

CeO2 doping boosted low-temperature NH3-SCR activity of FeTiOx catalyst: A microstructure analysis and reaction mechanistic study

Copper Doping Promotion on Ce/CAC-CNT Catalysts with High Sulfur Dioxide Tolerance for Low-Temperature NH 3 –SCR

Effects of doping Mn, Cu and Fe oxides on polyhedron CeO2 catalyst during NH3-SCR reaction

C,N ‐modified TiO 2 ‐supported Mn–Ce–Co x ‐based catalyst for low‐temperature NH 3 ‐SCR

The Selective Catalytic Reduction of NO with Propene over Cu-supported Ti–Ce Mixed Oxide Catalysts: Promotional Effect of Ceria

Excellent Low-Temperature NH3-SCR NO Removal Performance and Enhanced H2O Resistance by Ce Addition over the Cu0.02Fe0.2CeyTi1-yOx (y = 0.1, 0.2, 0.3) Catalysts.