Abstract:Abstract It is always a difficult task to study the dynamic fracture of prefabricated cracks under stress wave loading. To investigate loadings of stress waves on dynamic cracks, a crack propagation testing configuration consisting of a one-point bend specimen loaded in split Hopkinson pressure bar (SHPB) was used, which loaded an unconstrained polymethyl methacrylate (PMMA) plate (120 mm × 60 mm × 5 mm) on the edge opposite to the cracked edge. A modified simple pre-cracked specimen geometry under impact stress wave loading to generate pure mode I crack at crack initiation was demonstrated, which can avoid the superposition and interference of various waves to facilitate the research. The numerical simulation was performed firstly by ABAQUS to prove the existence of the mode I field at the crack tip leading to crack propagation and indicate the stress distribution and evolution in the specimen caused by the propagation of the impact stress wave, analyze the propagation characteristics of the wave. Then dynamic caustics method in conjunction with high-speed photography was utilized in SHPB impact experiment. The propagation of shock stress wave in the specimen and its interaction with the prefabricated crack and the stress concentration at the tip of the prefabricated crack were analyzed. The corresponding stress intensity factor history is precisely determined. Finally, it is concluded that the observed distortion phenomenon at the impact point belongs to a caustic behavior under compression load, which reflects the stress concentration at the impact point. And the mode I failure occurs along the pre-crack direction. Specifically, the pre-crack shows obvious pure mode I crack propagation characteristics under symmetrical reflected tensile wave, the stress at the crack tip changes from compressive stress to tensile stress. And crack propagates under tensile stress wave reflected from its two free boundaries without crack, while the compressive stress wave can not make crack initiate and has little influence on crack propagation. Which agree with the numerical prediction.

The effect of crack orientation on the mode I fracture resistance of pinewood

Crack Propagation And Fracture Process Zone (Fpz) Of Wood In The Longitudinal Direction Determined Using Digital Image Correlation (Dic) Technique

Constraint evaluation and effects on selected fracture parameters for single-edge notched beam under four-point bending

On the high fracture toughness of wood and polymer-filled wood composites – Crack deflection analysis for materials design

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

The effect of fibre orientation on fatigue crack propagation in CFRP: Finite fracture mechanics modelling for open-hole configuration

Experimental and Numerical Investigation of the Fracture Behavior of Extruded Wood–Plastic Composites under Bending

Mode Ii Fracture Testing Method for Highly Orthotropic Materials Like Wood

Modeling crack propagation in wood by extended finite element method

Mode I and II Interlaminar Fracture in Laminated Composites: A Size Effect Study

Crack influence on load-bearing capacity of glued laminated timber using extended finite element modelling

Effect of fiber orientation of adjacent plies on the mode I delamination fracture of carbon fiber reinforced polymer multidirectional laminates

Influence of Specimen Width on Crack Propagation Process in Lightly Reinforced Concrete Beams

Effect of crack size, thickness and span on the transverse mode I fracture characteristics of laminated flattened-bamboo lumber

Parametric analysis of dynamic crack propagation of concrete bending beam based on the extended finite element method

Characterization of mode II delamination behaviour of poplar plywood and LVL

The Gap Test: Effects of Crack Parallel Compression on Fracture in Carbon Fiber Composites

Experimental characterization and numerical modelling of the translaminar fracture of woven-ply hybrid fibers reinforced thermoplastic laminates

Effect of Crack Interaction on Dynamic Behavior of Rockunder Impact

Dynamic propagation behaviors of pure mode I crack under stress wave loading by caustics