Abstract:Broadband millimeter-wave power amplifiers have attracted much attention and have wide applications for 5G communication, satellite communication, radar, sensing, etc. Yet, it is challenging to design a power amplifier with broadband small-signal gain and power performance simultaneously. In this study, a transformer-based symmetrical magnetically coupled resonator (MCR) matching network for broadband output matching and stagger-tuned MCRs are used to achieve both broadband small- and large-signal performance. Also, to enhance the gain for the power amplifier, a three-stage common-source pseudo-differential structure is adopted to mitigate the low-gain issue due to stagger tuning, and the shunt resistors aimed to decrease the Q factor of the MCRs. We used the in-phase two-way current combined with microstrip transmission lines to increase the output power. Designed in 65 nm bulky CMOS technology, the power amplifier presents a 3 dB small-signal gain bandwidth from 25.8 GHz to 36.9 GHz, indicating a peak gain of 25.87 dB at 30.5 GHz. The power amplifier demonstrates a 17.84 dBm saturated output power (Psat) at 31 GHz and a 24.37% peak power added efficiency (PAEmax) at 28 GHz. The power amplifier achieves a flat Psat of 17.44 ± 0.4 dBm, a PAEmax of 22.59 ± 1.78%, and an OP1dB of 13.78 ± 0.31 dBm from 26 GHz to 36 GHz.

RapidIP — Automated design of a 220–260 GHz power amplifier in a 130 nm BiCMOS technology

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

A 60GHz power amplifier with 12.1 dBm & P1dBCP in 0.18um SiGe BiCMOS process

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

Triple-Stacked FET Distributed Power Amplifier Using 28 nm CMOS Process

A 220-GHz InP DHBT power amplifier designed by adaptive impedance inner-stage matching (AIISM) technique

A 130–150 GHz Power Amplifier for Millimeter Wave Imaging in 65-Nm CMOS

A Wideband Power Amplifier in 65 nm CMOS Covering 25.8 GHz–36.9 GHz by Staggering Tuned MCRs

Optimized Design of Low Power 90 nm CMOS Low Noise Amplifier for 60 GHz Applications

A broadband, high isolation millimeter-wave CMOS power amplifier using a transformer and transmission line matching topology

A Ka-band 27.6-dBm power amplifier with a compression-state large-signal matching approach in 130-nm CMOS SOI technology

Design of Ka-Band Broadband High-Gain Power Amplifier in 65-Nm CMOS

A 0.1–1.2 GHz CMOS Ultra-Broadband Power Amplifier

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

A Broadband Doherty Power Amplifier Design by Optimizing Its Load Modulation Network

The design and realization of a highly linear power amplifier module for a WiMAX/WiBro (802.16e) base station

Millimeter-Wave Devices and Circuit Blocks up to 104 GHz in 90 nm CMOS

A 130nm CMOS power amplifier driver for a 40 GHz radio-over-fiber system

A 180 GHz High-Gain Cascode Amplifier in 130-Nm SiGe Process

Fully Integrated CMOS Power Amplifier With Efficiency Enhancement at Power Back-Off