Abstract:Brass cladding copper stranded wire with an outer diameter of 10mm and core material of d2.12mm×7 strand was prepared by solid-liquid composite method with continuous pouring process for clad. Compared with the cladding welding method which requires multiple drawings to make the composite welding wire achieve metallurgical bonding, it saves a lot of manpower and material resources and shortens the production cycle. The bonding mechanism of brass and copper was analyzed by experiments, meanwhile, the effects of brass melt temperature and casting speed on the surface quality and interface bonding quality of the composite wire were investigated. The results show that, on the one hand, increasing the melt temperature of brass and reducing the casting speed can inhibit the surface defects of the composite. On the other hand, reducing the temperature of the brass melt and increasing the casting speed can inhibit the excessive element diffusion at the bonding interface, thereby reducing the degree of surface erosion of the copper strand. The final reasonable process parameters are as follows: the brass melt temperature is 970°C∼990°C, the traction speed is 40mm/min∼80mm/min, and the cooling water volume of the crystallizer is 450L/h. The prepared brass cladding copper stranded wire has good quality, Vickers hardness is between 80∼85HV, and tensile strength is between 265∼297MPa. Elongation after fracture is 40.3%∼43.9%, conductivity is 53.8∼62.1% IACS.

Valve copper alloy material and preparation method thereof

Copper alloy material and manufacturing method for lead-free brass ball valve component

Study on Material Performance of Drilling Throttle Valve Core

Influences of Ni/Cu/Cr3C2 Composite Additive on Microstructure and Properties of WC–10Co Fine Grained Hardmetal

Enhanced the Mechanical Properties and Corrosion Resistance of Ultra-Coarse Grain WC-8Co Cemented Carbides by the Introduction of Cu and Ni

Sand casting of surface alloyed butterfly valve with improved hardness and corrosion resistance by incorporating metal powders in-mold coatings

A copper tungsten composite material and its preparation method

Extending the Lifetime of Copper-beryllium Alloys as Plastic Injection High-end Needle Valve Mold Nozzle Tips Through a Heat-treatment-based Microstructure Optimization Approach

Microstructural Evolution and Deformation Behavior of Copper Alloy During Rheoforging Process

Preparation method of carbon nano tube enhanced copper-based composite material

Method for preparing copper-tin-nickel alloy powder by water atomization

Valve materials and design

Novel tungsten copper composite material and preparing method thereof

Zirconium-strontium composite micro-alloyed high-toughness corrosion-resistant low-silicon-content aluminum-silicon-copper cast aluminum alloy and preparation method

Effect of Al Content on Corrosion Resistance of Cu-22.7Zn-Al-1.0Ni Brass

Chemical Composition of New Copper Alloys for Machining and Its Effect on Their Susceptibility to Corrosion Cracking

Effect of Process Parameters on Surface Quality and Bonding Quality of Brass cladding copper stranded wire Prepared by Continuous Pouring Process for Clad

Silicon vanadium nitride microalloy and preparation method thereof

Titanium alloy and stainless steel electron beam welding filler material, and preparation process and method thereof

Copper-based alloy material for sliding bearing

Development of Steel for Valve Spring of Automobile Engine